|
Forums59
Topics1,057,775
Posts14,290,442
Members144,614
| |
Most Online39,925
Dec 30th, 2023
|
|
 798 SI transducer mount location???
#6299156
06/15/11 06:10 PM
|
Joined: Apr 2011
Posts: 542
Western
OP
Pro Angler
|
|
OP
Pro Angler
Joined: Apr 2011
Posts: 542 |
In the picture you see it mounted (transducer), I was going to move it closer to the center of the transom. The transom has a "bow" towards the outside. This would be about 6-8" from my Lower unit with trim all the way down and around 12+ from the prop. I would rather had got the through transom mount, but I'm stuck with this one. Thoughts?? I can post a photo with the trim down if that would help? 
|
|
|
Re: 798 SI transducer mount location???
[Re: Western]
#6299405
06/15/11 07:13 PM
|
Joined: Apr 2011
Posts: 542
Western
OP
Pro Angler
|
|
OP
Pro Angler
Joined: Apr 2011
Posts: 542 |
Where I am pointing is where I'd like to put it, just leery of putting a bunch off holes in. 
|
|
|
Re: 798 SI transducer mount location???
[Re: Western]
#6300105
06/15/11 10:13 PM
|
Joined: May 2009
Posts: 328
Captain Chris
Angler
|
|
Angler
Joined: May 2009
Posts: 328 |
No screw holes necessary...EVER!
|
|
|
Re: 798 SI transducer mount location???
[Re: Captain Chris]
#6305391
06/17/11 11:00 AM
|
Joined: Sep 2006
Posts: 2,975
Doug Vahrenberg
Extreme Angler
|
|
Extreme Angler
Joined: Sep 2006
Posts: 2,975 |
Are you wanting on plane readings too? If you mount higher you will not get 2D readings on plane speeds and would need a second 2D only transducer and Y Cable.
 Website: www.dougvahrenberg.comSponsored by: Skeeter, Yamaha, MinnKota, Humminbird, LakeMaster, Transducer Shield & Saver, LuckyCraft, Dobyns Rods, Daiwa, Dave's Custom Baits, Omega Custom Tackle, Browning Eyewear, Elite Tungsten Co., Angler Innovations, Massey Ferguson.
|
|
|
Re: 798 SI transducer mount location???
[Re: Doug Vahrenberg]
#6306567
06/17/11 04:51 PM
|
Joined: Apr 2011
Posts: 542
Western
OP
Pro Angler
|
|
OP
Pro Angler
Joined: Apr 2011
Posts: 542 |
Doug, actually it would be a bit lower. currently the transducer is at an off angle, so on SI, I get a small bit of blockage from the lower unit on the left side. ( Transom curves slightly)
It is flat or parallel in the center, so I was going to move it where I was pointing in the photo, just didn't know if anyone could see a potential headache.
The thru-hull transducer would have been great, but I have already installed mine.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
