Bought a 2003 Kenner with a 125 Mercury on it. Took the boat out for the first time today and it runs great. The rig had very little use on it and it shows. Everything is super clean and nice.... except for the live well aerator. This boat has a "live well fill" position on the switch and that works. However, the other position on the switch, which I believe is labeled recirculation (aerator I presume), does nothing. Where is this pump located that does the aerating?

Also, can't find a fuse block anywhere. Does anyone know where I can find a Kenner book or service info showing where these are located?

Thanks in advance for any help you might be able to give me.

The aerator/recirculator was an option and not standard on Kenners. The switch is there but not connected if the aerator wasn't installed. The fuse block should be located in the upper back left (facing the bow) under the console. I have a 19VX which is similar to yours as far as the wiring and live well are concerned. You install an aerator/re circulator relatively easy if

Thanks, I will check with the previous owner again. I was fairly certain he said the aerator was working, but could be mistaken. Will check on that location to the fuse block. Thanks again.

Can you tell me what each of these are?
"A" is where the water comes in when I fill the livewell.
"B" ????
"C" ????

I assumed "A" doubled as a aerator also, but now I don't know???

Is it possible it is a recirculator?
- What does recirculation do?
- If it recirculates water, from where? Just keeps the water stirred up or from outside?

All mine has is what you have labeled as "A". "B" & "C" would be the re-circulator points. B is the intake and C the supply/discharge. You do have the option. Now as far as getting it working, start with the fuse and work your way to the pump. I have no clue where they would have located it. I suppose it would have been possible that when it was wired they wired it with the aerator pump and not separately making it turn on everytime the aerator is turned on.