texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Bassplay3474, Triton022, Spark1946, cmbash, Willy91
119605 Registered Users
Top Posters(All Time)
TexDawg 124,591
hopalong 121,182
Bigbob_FTW 104,333
Bob Davis 95,910
John175☮ 86,135
Pilothawk 83,922
Mark Perry 74,867
Derek 🐝 68,498
JDavis7873 67,416
Forum Statistics
Forums59
Topics1,057,253
Posts14,281,850
Members144,606
Most Online39,925
Dec 30th, 2023
Print Thread
Page 1 of 2 1 2
steering question #8110738 10/14/12 06:55 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
I have a 1994 stratos 285 pro xl with an evenrude 150 on it. steering is stiff I unattached it from the motor and the motor turns freely. it has a dual cable setup and i notice the threaded tube that one of the cables goes through is bent and needs to be replaced. I purchased the new tube but I dont have the equipment to hang the engine inorder to change. Does anyone have a recommondation that is not going to break the bank. Boat is in the saginaw area.

Thanks,
Shayne.


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Re: steering question [Re: shayne38] #8112919 10/15/12 10:28 AM
Joined: Sep 2008
Posts: 121,182
hopalong Offline
Pescador Loco
Offline
Pescador Loco
Joined: Sep 2008
Posts: 121,182
should be just 4 screws on the tube, take out the cable then replace the tube/reinstall cable.


" Hop, set the hook"!
hopalong 99,999
TexDawg 99,999
FJB! not my president by a long shot!

lake fork FISHERMANS COVE MARINA/reservations - 903 474 7479
Re: steering question [Re: hopalong] #8112978 10/15/12 11:36 AM
Joined: Nov 2006
Posts: 2,952
T
TLW Online Content
Extreme Angler
Online Content
Extreme Angler
T
Joined: Nov 2006
Posts: 2,952
Since tha cable is to tight to pull with it mounted your best bet is renting a motor hoist. You "might" be able ta pull tha tube, cable and all but will be kinda tough ta do that way. Might test your patience!!! Especially puttin' it back.....

Re: steering question [Re: hopalong] #8113926 10/15/12 05:00 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
Originally Posted By: hopalong
should be just 4 screws on the tube, take out the cable then replace the tube/reinstall cable.

do they make a special wrench in order to take those screws out because i have every wrench for repairs to a car and they will fit on the boly but you dont have any clearance to turn it.


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Re: steering question [Re: TLW] #8113932 10/15/12 05:02 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
Originally Posted By: TLW
Since tha cable is to tight to pull with it mounted your best bet is renting a motor hoist. You "might" be able ta pull tha tube, cable and all but will be kinda tough ta do that way. Might test your patience!!! Especially puttin' it back.....
do you happen to know of anyone who change it cause if I have to pull the engine i much rather have someone who has done it cause i would like to operate the boat again. lol.


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Re: steering question [Re: shayne38] #8114043 10/15/12 05:32 PM
Joined: Oct 2005
Posts: 20,755
kingdad101 Offline
TFF Guru
Offline
TFF Guru
Joined: Oct 2005
Posts: 20,755
Quote:
do you happen to know of anyone who change it


kinda hard ,when we don't know where you are..

Re: steering question [Re: shayne38] #8114907 10/15/12 09:38 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
Saginaw ,near Ft.Worth


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Re: steering question [Re: kingdad101] #8118070 10/16/12 03:58 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
Originally Posted By: kingdad101
Quote:
do you happen to know of anyone who change it


kinda hard ,when we don't know where you are..
Saginaw ,near Ft.Worth


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Re: steering question [Re: shayne38] #8118345 10/16/12 05:04 PM
Joined: Nov 2006
Posts: 2,952
T
TLW Online Content
Extreme Angler
Online Content
Extreme Angler
T
Joined: Nov 2006
Posts: 2,952
I may be home a lot next week. If so you can bring it by here and I'll see what we do with it.......I'm not to far away.

Re: steering question [Re: TLW] #8122611 10/17/12 03:45 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
Originally Posted By: TLW
I may be home a lot next week. If so you can bring it by here and I'll see what we do with it.......I'm not to far away.
that would be awesome if you want to give me a call my cell number is 214-769-6835 if by chance I dont answer just leave me a number i can get back to you at and we can go from there. Thank you,

shayne.


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Re: steering question [Re: shayne38] #8124633 10/18/12 01:04 AM
Joined: Nov 2006
Posts: 2,952
T
TLW Online Content
Extreme Angler
Online Content
Extreme Angler
T
Joined: Nov 2006
Posts: 2,952
I'll give ya call first part of tha week............

Re: steering question [Re: shayne38] #8125677 10/18/12 08:14 AM
Joined: Nov 2009
Posts: 770
P
Performance Outboards Offline
Pro Angler
Offline
Pro Angler
P
Joined: Nov 2009
Posts: 770
Just split the aluminum tube that is stuck on the cable. Use a hawk saw, or a cut off wheel in a electric drill. You sure dont need to remove the engine thats for sure. That tube is aluminum, it will cut easly. The cut off wheel and atachment for the drill is at home depot or any hardware store for under 20.00. Have any questions call me. 281-312-9856 Cary


Call & Arrange your powerhead re-build today! I can work with trade-ins & I'll give you more for your core! Need a boat mechanic to come to you? I'm a Mobile Marine Tech. also. Call & schedule today! 281-312-9856
Re: steering question [Re: shayne38] #8125693 10/18/12 09:19 AM
Joined: Sep 2008
Posts: 121,182
hopalong Offline
Pescador Loco
Offline
Pescador Loco
Joined: Sep 2008
Posts: 121,182
my tube was put on with allen heads, this makes removal easier.


" Hop, set the hook"!
hopalong 99,999
TexDawg 99,999
FJB! not my president by a long shot!

lake fork FISHERMANS COVE MARINA/reservations - 903 474 7479
Re: steering question [Re: shayne38] #8129637 10/19/12 08:33 AM
Joined: Nov 2006
Posts: 2,952
T
TLW Online Content
Extreme Angler
Online Content
Extreme Angler
T
Joined: Nov 2006
Posts: 2,952
Originally Posted By: shayne38
that would be awesome if you want to give me a call my cell number is 214-769-6835 if by chance I dont answer just leave me a number i can get back to you at and we can go from there. Thank you,

shayne.


Tuesday?

Re: steering question [Re: shayne38] #8131138 10/19/12 05:46 PM
Joined: Jun 2012
Posts: 344
S
shayne38 Offline OP
Angler
OP Offline
Angler
S
Joined: Jun 2012
Posts: 344
Tuesday is perfect


Pro staff:
Denali Rods- http://denalirods.com/
Nutech Lures- http://nutechlures.com/
General Data Tech- http://generaldatatech.com/
Maple Lake Lures- http://maplelakelures.com/
Rage Fish Attractants-http://ragefishattractants.com/
Lake fork tackle-http://www.lftlures.com/
Page 1 of 2 1 2
Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3