I have 16 Bee Ready Rod Holders on my boat had them only a few months and the yellow parts on them are now all sticky like they have melted. It makes a mess all on your hands and my rods just wondering if any one else has had this problem? They are outside but not direct sun light.

Thanx,
JJ

No. Mine have been through two boats and many many years and no issues.

I might call pro angler then.

I would. They are good guys over there.

I just sent em a email

Mine have never gotten sticky either. They've faded some but that's expected being outside.

Yea fading is expected and not a problem, they emailed me back today saying he has never heard of that in 10 years.

Hmm. If they can't fix it for some reason, I'd expect you could strip it off and re dip in Plastidip

+1

I'd do pink or lime green

Mine have gone thru two boats too, no problems

Is that all he said ??? He didnt say he would replace ?

He said, he has not heard of that in 10 years, asked if I have cleaned them with something or if gas has got on them. Something�else is causing this on your boat only.�Some chemical has gotten on them. I responded to his email I spray my boat down with water when I use it I don't use any soap or anything, do you sell just that piece or do I have to buy a whole set up? I sent that back as soon as I got his response and I have not got a response yet. For $20 each and $81 each for the 3 rod holder. I am hoping they can replace or discount me the parts to fix em.

I might just cut em off and dip em save the trouble

Some of mine got sticky to. I just replaced the yellow with Reychem heat shrink.. Problem solved.

No problems with mine other than fading a little!