|
Forums59
Topics1,057,727
Posts14,289,664
Members144,613
| |
Most Online39,925
Dec 30th, 2023
|
|
 Mercury flywheel removal
#708974
05/05/05 10:36 PM
|
Joined: Mar 2004
Posts: 394
Hexabob
OP
Angler
|
|
OP
Angler
Joined: Mar 2004
Posts: 394 |
I have a mid 90's 15hp and I can't figure out how to get the flywheel off. It doesn't have the 3 holes to use a flywheel puller, and it doesn't look like an internally threaded flywheel. 
|
|
|
Re: Mercury flywheel removal
#708975
05/06/05 01:41 PM
|
Joined: Dec 2002
Posts: 3,832
Tommy Yetts
TFF Team Angler
|
|
TFF Team Angler
Joined: Dec 2002
Posts: 3,832 |
I don't recognize that flywheel but the way we remove some of the old Chrysler flywheels was to put the nut back on the shaft until it just covers the threads. Take a pry bar and carefully put upward pressure, from the underside of the flywheel, then strike the crankshaft with a dead blow hammer. Be carefull not to get too violent with the hammer because you do not want to damage the crankshaft.
Good Luck, Tommy Yetts
Rockwall Marine
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
