|
Forums59
Topics1,056,974
Posts14,277,689
Members144,600
| |
Most Online39,925
Dec 30th, 2023
|
|
 Rebuilding trim ram end cap
#5365898
10/02/10 01:40 AM
|
Joined: Feb 2005
Posts: 214
Seaswirl C.C.
OP
Outdoorsman
|
|
OP
Outdoorsman
Joined: Feb 2005
Posts: 214 |
I'm rebuilding trim ram end caps on '78 johnson 115 hp tnt cross flow 3-wire tilt & trim. Any suggestions on tightening the end caps once the outer o-ring and back-up ring are inplace. Can't tell if there is a trick to getting this sealed correctly.
|
|
|
Re: Rebuilding trim ram end cap
[Re: Seaswirl C.C.]
#5366424
10/02/10 10:18 AM
|
Joined: May 2003
Posts: 11,586
gary purdy
TFF Guru
|
|
TFF Guru
Joined: May 2003
Posts: 11,586 |
They have an "O"ring seal at the top above the threads. Apply light coat of grease their. You remove and tighten the cap with a tool made for this.
The world will not be destroyed by those who do evil, but by those who watch them without doing anything. Remember what He has done and remember that He is not done yet!-- GOD IS GOOD
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
