|
Forums59
Topics1,056,875
Posts14,276,088
Members144,598
| |
Most Online39,925
Dec 30th, 2023
|
|
 gear rod seal at h2o pump
#5338474
09/24/10 02:09 PM
|
Joined: Feb 2005
Posts: 214
Seaswirl C.C.
OP
Outdoorsman
|
|
OP
Outdoorsman
Joined: Feb 2005
Posts: 214 |
'98- 150HP EVINRUDE. I notice a little gear oil on the gear rod on the top gear case cover when I replaced the waterpump kit.
Is that part of the gear case sealed by the 1" round rubber disc that slides over the gear rod or is there another seal at the top of the top cover of the gear case that goes bad and needs replacing?
(Advise needed)......, don't want water in the gears, knothing about seal in manual.
|
|
|
Re: gear rod seal at h2o pump
[Re: Seaswirl C.C.]
#5339047
09/24/10 04:16 PM
|
Joined: Dec 2009
Posts: 1,482
RANGER SKI
Extreme Angler
|
|
Extreme Angler
Joined: Dec 2009
Posts: 1,482 |
there is a o ring in the gear shift rod housing and probably needs to be replaced
|
|
|
Re: gear rod seal at h2o pump
[Re: RANGER SKI]
#5339962
09/24/10 07:41 PM
|
Joined: Feb 2005
Posts: 214
Seaswirl C.C.
OP
Outdoorsman
|
|
OP
Outdoorsman
Joined: Feb 2005
Posts: 214 |
I think the seepage I saw was the gasket seal I used when I installed the waterpump housing. There no longer is a seal in the top of the new water pump cover around the drive shaft there is a gap between the housing and drive shaft per latest design. The seepage should go away once I run on the lake.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
