|
Forums59
Topics1,059,168
Posts14,315,056
Members144,646
| |
Most Online39,925
Dec 30th, 2023
|
|
 Humminbird AS SIDB Y cable problem
#4836187
05/09/10 05:11 PM
|
Joined: Mar 2010
Posts: 76
EtexSkeeter
OP
Outdoorsman
|
|
OP
Outdoorsman
Joined: Mar 2010
Posts: 76 |
I have recently installed this cable to run two transducers. I am running the SI ducer as well as the dual cone ducer for high speeds. Every time I plug the cable into the unit the depth reading goes nuts and the side imaging starts to scroll very slowly. Is there somthing I am doing wrong here?
Thanks,
Les
|
|
|
Re: Humminbird AS SIDB Y cable problem
[Re: EtexSkeeter]
#4839683
05/10/10 04:18 PM
|
Joined: Jun 2008
Posts: 321
Eddie (alias Eddie@Humminbird)
Angler
|
|
Angler
Joined: Jun 2008
Posts: 321 |
double check the Y cable to make sure the SI is plugged into the SI side, 2d puck to the Dual Beam side. Try restoring the factory defaults or set the Transducer to 200kHz. When the 83kHz is on you will see a slower scroll speed because the unit is having to send out 200, 83 and 455 pings.
|
|
|
Re: Humminbird AS SIDB Y cable problem
[Re: Eddie (alias Eddie@Humminbird)]
#4840063
05/10/10 05:37 PM
|
Joined: Jan 2007
Posts: 19,726
Bobcat1
TFF Guru
|
|
TFF Guru
Joined: Jan 2007
Posts: 19,726 |
If the dual cone ducer is a shoot thru hull you could have an air pocket too. Poor water in your hull on the puck next time you are out. If it starts working then you have an air pocket between the ducer and the hull. Be sure none of the transducer cables are wrapped around a tachometer cable too.
Bobby Barnett
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
