I have a 92' Evinrude Intruder, idles rough and dies at low rpm's idle or trolling, also makes a sporadic "spitting" missing at low rpm also, any ideas?

Any help will be appreciated.

Thanks
Joe

Sounds like a leaking intake manifold gasket.

thanks Stratos, is that very difficult to do?

had mine (96 evinrude 150) do the same thing, ran a can of seafoam through it and that helped alot.....always run marine stabil with the gas as this ethanol [censored] in our gas sucks for outboards

its running lean probably dirty carbs or is that a fitch motor

pm sent

I'd guess dirty carbs too. Make sure there are no leaks in any of the fuel lines either. ( air leaks too). Also Check your plugs after letting it run , for water droplets or rust. If so....might be a head gasket....but probably not.

My first guess would be carbs. Try seafoam

Spanky, left you a message on cell.