was on the lake and the trim quit just clicks when i try to lift or lower tried all 3 switches in the boat?

Check for corrosion on your crankin battery posts... it would be very unlikely that all 3 switches and both solenoids went bad at the same time. Corrosion between the terminal and battery posts can cause ground and power problems.

The other thing it might be is the brushes or commutator/ armature are worn in the TnT motor.

Bazz

Also not knowing what motor you have, some have a plug connector betweem the relays and the trim motor.

2003 yamaha 250 v max

Just got mine out of the shop did the same thing. It was the motor had it replaced $ 700.00.

Before you replace the motor remove and replace the 40 amp CB, these things can check good but not work under a load, hope this helps

Check your relays! Could be a $15 quick fix.

Where are they located?

Most relays are about a 1" x 1" square black switch. Make sure they are still plugged in good. Not likely they would both go out at the same time, but unplug them and switch sides. You can but a new relay at the auto parts store. Tell them you need an A/C relay. Hope it works.....

Are they on the boat or motor and where

has any one fished the mcdonalds tourament &won money

on the motor. Next to your trim switch follow the harness to the relays.

Trim solenoid

Check your fuses! mine did the same thing. it was the fuse in the engine.