Went fishing this morning and after a couple hours my forward imaging screen started showing everything at a 45 degree angle. I had a fully charged 10 amp 20 volt dewalt battery running. I tried restarting , unplugged power cord, reset default settings and moved transducer manually but still couldn't get screen to work right. Does anyone know how to fix this? I even changed batteries. Can anyone please help me?

You can try recalibrating AHRS -- you can also see if it works with AHRS turned off as a work around. My unit worked fine for several months and then started doing this. The only long term fix, for me, was to replace the transducer.

reposted below with working link

If I have to replace the tranducer is that covered under waranty? I have never bumped anything with it and I think that's $1200.

Watch the video above. It shows you how to adjust it. I had it happen to mine for some unknown reason (probably my own doing while messing with the settings). Easy to correct.

Could have accidentally got switched to perspective 😁

Im sorry but the video is not working. Can you send the link? Your really getting my hopes up saying it's an easy fix.

Mine did the same thing. I did the "reset to factory settings" and it leveled out.
Hope you get it cleared up.

Good Luck,
Bozz

Unfortunately the reset to default settings didn't work for me.

That video was awesome! Thank you so much. I am going fishing tomorrow, yea ha.

Didn't realize the first time i posted it the link wasn't working. Should fix your problem though.

Is this the new version?

My Livescope is the new one. I did not get perspective mode on mine