2013 FX20.
The live well will not recirculate or pump out. It fills and aeration just fine but if try to recirculate or pump out the lights start flashing on the console for both on and auto…just replaced the cartridge and same problem. Out of ideas. Thank you in advance for help or suggestions.

Did you check the fuse or breaker? Did you check for power where you connected the new cartridge? Also check for power at the fuse, especially if you have a touch panel.

Thanks Chris. I’m unable to locate a fuse panel. It’s not under the console on under day box. They are touch panel and not rocker switches. Guess next step is to remove the 4-bank charger(in the way) and chase wires to see if an inline fuse.

Try this...

"Simply hold down the flashing button on your keypad for 3 seconds and it resets."

This was on another forum when someone tripped the "fuse" in the "brain" for the courtesy lights. It was a 2008 20i, which IIRC is the same box as the 2013-2014 FX20. They did go to fuses in 2015...

Well, I am probably wrong...

There has to be a fuse holder somewhere. If not below the day-box, check behind the wall between the console and the starboard rod box.

Here is the Owners Manual. It doesn't fully help, but it shows that the system is the same as the 2015 I have, except I do have a fuse panel (though the wiring is a little on the small size for today's electronics...

https://skeeterboats.com/sites/default/files/2014_Skeeter_Freshwater_Owners_Manual.pdf

Mine has been doing that too. Once it was a worm in the pipes and once it was a piece of shell. Easy fix, unscrew both hole screens, shut valve off and fill little with water and shop vac out, whatever is in there is come out in the vac. Or take both aerators out and blow it out, but this way you won't see what was in there. when lights are blinking it is tell you something aint working. GOOD LUCK

One live well won’t pump out but does everything else, pump is ok , found out it was touch pad. New touch pad $400 now just pull plug to empty till something else breaks then I’ll replace pad. Could put separate switch for pump out but don’t feel like tearing apart and running wires pulling plug isn’t that big of a deal only when have co-angler that live well gets used.