***Price Reduced*** 2017 Tracker Grizzly 1648 MVX, Boat, Motor, Trailer, & Accessories for sale for $8000.

My son joined his high school bass fishing team, so of course I had to go out and buy us a new rig. This Grizzly has served us well for the occasional trips to the lake. The motor has very low hours on it, I would estimate below 20. We only used it to get us to and from our fishing spots and then hop on the trolling motor for the rest of the day. The most motor hours were seen when this Grizzly was used by us to rescue our neighbors during Hurricane Harvey. The boat has only been in a few fresh water lakes, never in salt water.

Sale includes:

• 2017 Tracker Grizzly 1648 MVX welded aluminum boat
• 2017 Tracker galvanized steel trailer in matching green paint
• 2017 Mercury 25hp ELHPT Fuel-injected 4-stroke tiller steer motor, w/hydraulic tilt, electric start, backup manual start, and kill switch
• 2019 MinnKota Terrova 12v 55lb Ipilot Trolling Motor w/spot lock, remote, bluetooth and foot control
• BPS 20 amp 2 bank battery charger, mounted in storage area under bow and rigged to charge TM and cranking batteries simultaneously through flush mounted charging port
• Trailer lights have been upgraded to waterproof LEDs, soldered to factory harness (no tap style connections to come loose)
• Mercury 4 blade prop (upgraded from factory 3 blade)
• 2 Cushioned, folding-back chairs (in like new condition)
• 2 Removable pedestals for seats (still have the plastic wrap on them)
• Navigation and all-around lights
• Electric horn installed under bow and activated by switch at stern
• Factory style electrical socket for trolling motor
• Factory installed spare tire carrier with spare wheel and tire
• GPS for trolling motor installed on bow and wired to TM battery
• Factory style electrical sockets for navigation lights installed at factory locations
• Factory style navigation light storage mounts. All-around light storage on starboard gunwale, navigation light storage mount in storage compartment at bow
• Ratchet strap tie downs for stern
• Transom saver for hauling
• Built-in rod storage tubes and bungee strap mounted along starboard side gunwale (bungee strap mount installed on port side and will include the 3 additional rod tubes for that side, which I have not installed yet)
• Shallow water SuperStik anchor mounted factory-style on port gunwale
• Triple rod storage tube mounted vertically along starboard stern area, by cranking battery
• 600 GPH built-in bilge pump, wired to switch on cranking battery box
• Uninstalled Marine grade carpet roll (enough to carpet all interior surfaces)
• Wooden paddle mounted to stern bench
• Additional Stainless seat mounting base installed on starboard stern bench (will include another stainless seat mounting base which has not been installed yet for the port side)
• Deep cycle and cranking batteries included

I wanted the boat to look as factory as possible, so as I added accessories, I would go to BP, take measurements, then come home and install the accessories in the factory locations. All electrical connections are either full runs to the battery, or they have been soldered to prevent loose connection issues out on the water. As you can see from the almost new tread on the original tires, the trailer has maybe 2000 miles on it, if that. I used only stainless steel screws/bolts or aluminum rivets to mount everything. This rig absolutely sips fuel and I have never used more than half a tank (6 gallons) on a full day of fishing. The trolling motor can run all day and then some on a full charge. With my son and his adult cousin, the trolling motor has no issue keeping us in position, even in a strong wind. I believe I covered everything. If you have any questions, please ask and thanks for looking!

Bump

Sent you a PM

Bump

Sent you a PM nice boat

Is this boat for sale still

Is this boat for sale ???

Is this a scam or has boat been sold? Geez take it down if it is sold .

Is this boat for sale?