Headed to the lake and one of my bearings went out. It’s a skeeter with vault hubs. Looks like everywhere around that sells vault hybrid grease bearings are closed for the holidays so I’m hoping to find a regular grease hub from tractor supply to get me home. Assuming my spindle is still in good shape (I think it is)... Any idea what size hub/bearing I should get?

generally the 1 1/8 , 1 1/16 is a pretty standard.

if you can pull the hub and take it in you should be able to compare race sizes

Thanks hop!

napa preffered if there is one close, they have a better selection of bearings and races if not a complete hub

Axle Load Capacity
Seal Outer & Inner Diameter


Inner Bearing Cone
1500#-2500#
1.98” x 1.38”


L44649
2900#-4200#
2.33” x 1.68” or 2.56” x 1.68”
L68149


https://www.pacifictrailers.com/blogs/boat-trailer-tips-advice/the-vault-hybrid-lubrication-system


not sure if this helps.
those are the rear seal and inner race dimensions

Isn't there a TFF'er that has a NAPA store ? In Wylie ?

If you're in Wylie area, Tiltman has a napa store off of 78 up that way.

What lake and where are you?

There probably is but unfortunately I’m over fishing squaw today. Thanks again for the help fellas

WAWI! go help the man, you squaw freak you.

The Squaw Creek curse strikes again!

Work or I probably would

FUN N SUN in cleburne isnt that far from squaw

Quick update... fun n sun and all the other trailer places were closed for the holidays. I was planning to try and replace the hub with a cheapo tractor supply hub but then realized my hub was the same one that has disk brakes, and it would have ended up being a lot more work. I decided to limp it home on the three legs. Made it from glen rose to I-20, and had a tire blow out. Managed to swing into an empty parking lot and swap my remaining tire and made it the final 23 miles home on 2 of my 4 tires. Stressful drive and thankful to make it back without getting stranded.

Dang.....glad you made it home safe.