Temp Alarm going off on Smart Craft Display

Temp Alarm going off on Smart Craft Display #12697819 04/01/18 02:07 AM
Joined: Dec 2009 Posts: 697 R roundman5150 OP Pro Angler
OP roundman5150 Pro Angler R Joined: Dec 2009 Posts: 697	My temp alarm went off today i looked down at my display and it was reading 98 degrees. i had the water pump changed 2 months ago and it has a good stream and the water pressure gauge is showing good pressure. Very concerned. Looking for some info Thanks

Re: Temp Alarm going off on Smart Craft Display [Re: roundman5150] #12697960 04/01/18 04:35 AM
Joined: Jun 2004 Posts: 1,509 Benbrook Tex O OPTI Extreme Angler
OPTI Extreme Angler O Joined: Jun 2004 Posts: 1,509 Benbrook Tex	What you are getting is a thermostat fault the motor is telling you that engine has not reached 106 degrees in 240 seconds and the reason for this is one of the thermostats has debri stuck in the thermostat not letting water heat up block...OPTI

Re: Temp Alarm going off on Smart Craft Display [Re: roundman5150] #12697989 04/01/18 07:35 AM
Joined: Feb 2015 Posts: 4,740 Magnolia, TX F Flippin-Out TFF Team Angler
Flippin-Out TFF Team Angler F Joined: Feb 2015 Posts: 4,740 Magnolia, TX	This kind of Smartcraft tidbit is good to know. I've been reading the manual for it, and what that instrument can do is nothing short of amazing. I plan to program a "trolling speed (by RPM selection)" so that I get a consistent/ideal speed for sonar graphing without having to finesse the throttle. I view it as an instrument vs. a "gauge" because of it's abilities.

Hop To