I resealed the whole lower unit with new seals and everything.I used triple guard grease for all bearing and evinride gasket sealer i pulled the bearing housing and resealed That also and greased it.My issues is I put everything back together and turn the prop by hand is really tight it will spin but you have to put a little pressure on it,Is this suppose to happen when you see reseal a lower unit? Do i need to run it awhile on the lake to loosen it up ? There is no binding when put in forward and reverse so I'm not sure what the deal is?

I would pull carrier back out and check the reverse gear thrust washer and thrust bearing.....OPTI

If you use the Sierra seal kit, the prop seals will be pretty tight for a while.

The Sierra seal kit is what I used,I checked the all the gears and bearing everything is is really good shape,Just tight.Guess I just need to break it in!