Looking for a 14 1/4, 25 pitch four blade stainless prop like a ballistic or a renegade for a 225 Johnson. I can't seem to find one anywhere online, can anyone point me in the right direction?

http://www.stevescustomprops.com/

Try Steves Props.

I have a 23 and a 27 X 13.75 you`re welcome to try. Have a 25 X 14.25 3 blade that was reworked for an Evinrude by Steve also you can try. The 225 Evinrude it was on expired. I don`t believe the 4 blades are that big of a diameter.

Ive got a 13 1/2" X 25 Renegade, but thats smaller diameter than you're looking for. Sorry

Curt is asking real reasonable price for his.

Why do you think you need such a big diameter four blade prop?
That's usually a very special need, like a tunnel flats rig or a V6 rigged pontoon boat.

Mr Goff has a point. I run a 14.5 inch 4 blade on my Majek RFL, just to keep bite when the motor is high and for shallow holeshot. What kinda boat is it for? I see Abilene on your profile and wouldn't think flats rig....but I live in Fort Worth an run one, hate to be presumptuous.

Thats what I'm wondering. Just curious. I ran the Renegade 13 1/2" on a Triton Tr20 with a 200. Had friends running same prop on 21' boats with 225/250's. I ran the 4 blade for rough conditions on bigger waters & a Raker 3 blade larger diameter otherwise.
Larger diameter Renegade is going to be harder to locate I imagine. Good luck.

PM sent

There are large diameter four blade props. They are used in high speed offshore boats and tunnel flats boats that are looking to minimize cavitation. Typically a cleaver blade that works good when it�s in a surfacing condition. They would be a turd on a bass hull.

Thanks for all the input, I�m not well educated in props. I just know my shaft is 14/14, we had a 14/14 x 25 renegade on it but lost it last year. Now we have a 14 1/4 23 pitch on and we don�t like how low we sit in the water. I was under the impression that I had to have a 14 1/4 prop on it. Is that wrong??

It�s been that way since we bought the boat 10 years ago

13 1/2"-14 1/4"-& 14 1/2" would be the DIAMETER of the props blades outside edge to outside edge. Not anything to do with shaft size. P is the angle of pitch the blade has. Usually 4 blade props are smaller diameter than 3 blade props. The differences are in prop shaft splines by brand of motor. Mercury, OMC (Johnson/Evinrude) ,Yamaha. That would be the prop "hub".
What you most likely lost & are looking for is a Renegade 4 blade 13 1/2" 25 P prop with OMC hub. I have one I'll take $175 cash for if you pick it up here. I have no use for it. It came off a Evinrude 200 Vindicator. Same lower unit as yours.

U still looking