|
Forums59
Topics1,058,646
Posts14,306,172
Members144,631
| |
Most Online39,925
Dec 30th, 2023
|
|
 Side image trolling motor setup
#11868100
10/06/16 08:58 PM
|
Joined: May 2007
Posts: 1,197
WackySenko
OP
Extreme Angler
|
|
OP
Extreme Angler
Joined: May 2007
Posts: 1,197 |
Have my helix fairly dialed until I hit the button to turn the tm on and then it goes to [censored]. Any ideas?gonna move my transducer as far away from the prop as I can but probably gonna be stumped after that.
"Its not an addiction...its a disease! and I LIKE it! keeps my sanity in this cruel world!"
|
|
|
Re: Side image trolling motor setup
[Re: WackySenko]
#11868103
10/06/16 08:59 PM
|
Joined: May 2007
Posts: 1,197
WackySenko
OP
Extreme Angler
|
|
OP
Extreme Angler
Joined: May 2007
Posts: 1,197 |
In a transducer shield/saver mount if that makes a difference.
"Its not an addiction...its a disease! and I LIKE it! keeps my sanity in this cruel world!"
|
|
|
Re: Side image trolling motor setup
[Re: WackySenko]
#11868113
10/06/16 09:04 PM
|
Joined: Nov 2010
Posts: 5,164
Wayne P.
TFF Celebrity
|
|
TFF Celebrity
Joined: Nov 2010
Posts: 5,164 |
You are getting RFI from the trolling motor. Nothing unusual about that.
Contact Humminbird Customer Service for help with that issue.
Give them more information than you have done here. What motor and how is the sonar unit powered.
Helix 12 CHIRP MEGA SI+ GPS G4N, SOLIX 10 G3, Helix 15 CHIRP MEGA SI+ GPS G4N,
Helix 8 CHIRP MEGA SI+ GPS G4N, SOLIX 12 G3, MEGA 360, MEGA LIVE TL , MEGA LIVE 2, Xplore 10
|
|
|
Re: Side image trolling motor setup
[Re: WackySenko]
#11868134
10/06/16 09:16 PM
|
Joined: May 2007
Posts: 1,197
WackySenko
OP
Extreme Angler
|
|
OP
Extreme Angler
Joined: May 2007
Posts: 1,197 |
Ok. Minnkota maxxum. Powered off one of my accessory wires. Think I just might have had higher expectations on the image I was going to get.
"Its not an addiction...its a disease! and I LIKE it! keeps my sanity in this cruel world!"
|
|
|
Re: Side image trolling motor setup
[Re: WackySenko]
#11868141
10/06/16 09:19 PM
|
Joined: Sep 2003
Posts: 5,886
Bruce's
TFF Celebrity
|
|
TFF Celebrity
Joined: Sep 2003
Posts: 5,886 |
You need to Run a new power wire all the way back to the batteries. And make sure you use a fuse.on it. If you can Run the wire down the side with out all the other wires. The interference will go away
Last edited by Bruce's Guide Service; 10/06/16 09:20 PM.
Fishing Texas lakes one at a time
|
|
|
Re: Side image trolling motor setup
[Re: WackySenko]
#11868323
10/06/16 10:35 PM
|
Joined: Aug 2011
Posts: 2,957
Bob Landry
Extreme Angler
|
|
Extreme Angler
Joined: Aug 2011
Posts: 2,957 |
The HD transducers are also less prone to electrical interference.
2015 Seaark 1872 MV CC Etec-90
Two Helix 12 CHIRP SI's, , MinnKota Riptide ST80/i-pilot Link, Bob's Hydraulic
2020 Robalo R200 CC, Yamaha 150
Bitter Gun Owner
Bitter Clinger
Armed Infidel
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
