Forums59
Topics1,039,546
Posts13,966,334
Members144,208
|
Most Online39,925 Dec 30th, 2023
|
|
Re: Bent power pole bracket
[Re: High wide and heavy]
#11515467
04/01/16 11:49 AM
|
Joined: Feb 2016
Posts: 60
High wide and heavy
OP
Outdoorsman
|
OP
Outdoorsman
Joined: Feb 2016
Posts: 60 |
I'm talking about the 90 degree L shaped bracket. It attaches one end to my jack plate and the other attaches t the actual power pole. I looked at it again and it is bent down and away from my boat. I just need a new bracket or it looks like I could bend this one. (I better have the new one on hand, my "bending" experience is not good.)
|
|
Re: Bent power pole bracket
[Re: Gary R]
#11516885
04/01/16 11:51 PM
|
Joined: Jun 2012
Posts: 1,390
Andrew Y'Barbo
Extreme Angler
|
Extreme Angler
Joined: Jun 2012
Posts: 1,390 |
The brackets are plate steel that's plasma cut and them bent. Not mine! I have Power Poles on both of my boats. And all brackets are aluminum, and powder-coated. Not steel! Correct. I said it wrong. 6:00am is not the best time for advise. Just like asking at 1:00am Aluminum plate. Not cast.
|
|
Re: Bent power pole bracket
[Re: High wide and heavy]
#11516899
04/01/16 11:59 PM
|
Joined: May 2008
Posts: 10,273
Rayzor
TFF Guru
|
TFF Guru
Joined: May 2008
Posts: 10,273 |
I left my power pole down one time and took off. It bent the bracket. Not bad enough to worry about though.
Be safe, Rayzor 2001 Triton Tx-21/225 Mercury EFI
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|