Need a little help. This is a 2011 unit with the digital wireless remote foot unit, model 55. It died and won't do anything. I checked the remote battery and it was OK at 3.2V. Main battery is 12.6V. I get no sound or movement from the motor at all. The four red lights that show the voltage are all lit in a test, so the motor is getting full voltage. The mechanical parts I can diagnose, the electronic parts I am lost.

Any help is fully appreciated.

I found this. Don't know if it will work or not. Look in your manual for resetting the remotes.


Reprogramming the Wireless Foot Pedal or Remote
NOTE: This activation procedure applies to the foot pedal and remote.
IMPORTANT: To activate multiple foot pedals or remotes, the motor must be unplugged from the power source and then plugged
back into the power source between activating each control device.
1. Unplug the battery cables from the power source. Wait 30 seconds and then plug the motor into the power source.
2. In less than ten seconds, press and hold the "+" and "�" buttons on either the handheld remote or the foot pedal controller simultaneously.

Thanks crawler. That was going to be my next move. I hate to delete anything for fear I can't get it back. But, I guess you can't lose what you don't have.

I'll give it a try.