I have acquired a slew of terminator spinner baits recently. The previous owner didn't have proper storage on their boat and almost all of the blades have long term water spots on them. Any ideas on what's the best way/cleaner to use to clean and polish them back up. They are all brand new otherwise, just suffering from poor storage. Thanks all!

You could scub then with scotchlite pads and polish with brasso. That might work. Blades usually have thin metal coatings. Scubbing them with abbrasives will reduce their brightness.

It is probably easier to replace the blades if they are rusty or corroded. Order blades from Tackle suppy stores.

Try some ketchup and see what you think.

That stuff they infomercial CLR should do it. CLR stands for calcium - lime - rust.

Come on guy Ketchup , really ?? Not being disrespectful just surprised.

Try it before you knock it.

toothpaste

Seen it work first hand, I was also sceptical