I have recently bought a 2011 Ranger Z520 and I was just going through the boat getting familiar with it, and I can't find the fuse box. I looked in all the rod boxes, under both consoles, and I didn't see it in or around the storage areas in the back of the boat. I may have just over looked it, but I had a friend with me and he was also unable to find it. I had a Xpress Aluminum boat before this so this isn't my first boat, but my first fiberglass bass boat. Any help with finding the fuse box would be much appreciated. Thanks in advance.

Mine is a little older than yours but the fuze panel is in the right rod box just in front of the console.

+1

That's where my dad's is too. He has a 2007 model. All my structure scan / Lowrance equipment is mounted there. I will look a little closer around that stuff and see if it has just been camouflaged by the structure scan. Thanks!

I have an 09' and there are no fuse boxes on the newer models. All breaker trips are reset with the tourch pad or the large circuit breaker mounted near the battery. If a circuit trips, the corresponding LED will start flashing on the key pad along with the Stop LED. To reset the breaker, depress and old the corresponding Button on the key pad until the LED stops flashing. There are some unswitched devices which will cause the stop Switch only to flash on a circuit breaker trip. If the Stop switch only is flashing, you hold it down until it stops flashing. If a circuit will not reset, you likely have a dead short somewhere and you will have to find it. I would get an owners manual if you do not have one and use it because it is not your simple fuse panel electrical system anymore.

Thanks a lot. I will have to find my manual and get familiar with the new set up.