|
Forums59
Topics1,049,979
Posts14,149,731
Members144,432
| |
Most Online39,925
Dec 30th, 2023
|
|
 Re: Water pressure on 2000 Mercury 200 EFI?
[Re: BassCat'99]
#5325470
09/20/10 11:05 PM
|
Joined: Jan 2005
Posts: 1,904
heybaylor
Extreme Angler
|
|
Extreme Angler
Joined: Jan 2005
Posts: 1,904 |
where in the motor is the water pressure guage "tapped in ?
hopefully in the top of block to poppit drain,,
I have seen some installation into the "pee-line "(wrong place)
heybaylor
|
|
|
Re: Water pressure on 2000 Mercury 200 EFI?
[Re: heybaylor]
#5341130
09/25/10 01:17 AM
|
Joined: Sep 2010
Posts: 11
2011Alpha211
OP
Green Horn
|
|
OP
Green Horn
Joined: Sep 2010
Posts: 11 |
Pressure gauge is tapped in at the hose that comes from top of #1 cylinder head. came that way when i bought the boat. Have installed new water pressure gauge since then.
|
|
|
Re: Water pressure on 2000 Mercury 200 EFI?
[Re: 2011Alpha211]
#5341132
09/25/10 01:18 AM
|
Joined: Sep 2010
Posts: 11
2011Alpha211
OP
Green Horn
|
|
OP
Green Horn
Joined: Sep 2010
Posts: 11 |
Think its gonna be ok. Just a little more mindful of it since had it rebuilt.
|
|
|
Re: Water pressure on 2000 Mercury 200 EFI?
[Re: 2011Alpha211]
#5341476
09/25/10 03:44 AM
|
Joined: Apr 2010
Posts: 190
2Strokes
Outdoorsman
|
|
Outdoorsman
Joined: Apr 2010
Posts: 190 |
Those numbers are fine. And remember that you have a temp sensor that will put the motor in gauardian if you do overheat. Most guages wont even read at idle. Once you crack past 1200-1500 rpm those guages will pick up. And those guages you have are most likley analog so they are usually off several psi.
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
