Forums59
Topics1,051,761
Posts14,183,315
Members144,469
|
Most Online39,925 Dec 30th, 2023
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: Pondbass]
#4939234
06/04/10 02:28 PM
|
Joined: Apr 2007
Posts: 596
JSIG
Pro Angler
|
Pro Angler
Joined: Apr 2007
Posts: 596 |
Wow, can't wait to see her when she's done. Nice work for sure!
John 1998 Promaster 190V, Johnson 150
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: JSIG]
#4940785
06/04/10 08:06 PM
|
Joined: Feb 2010
Posts: 238
BacklashedLund
Outdoorsman
|
Outdoorsman
Joined: Feb 2010
Posts: 238 |
you can never have enough cup holders! nice job!!as many have said, you are very talented. tom
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: BacklashedLund]
#4941250
06/04/10 09:20 PM
|
Joined: Jun 2009
Posts: 2,008
fordnut
Extreme Angler
|
Extreme Angler
Joined: Jun 2009
Posts: 2,008 |
Talented Yes not to mention determined, Looks good something you will definately be proud of.
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: fordnut]
#4944687
06/06/10 12:36 AM
|
Joined: Mar 2009
Posts: 559
Austintatious
OP
Pro Angler
|
OP
Pro Angler
Joined: Mar 2009
Posts: 559 |
UPdate:
No pics yet as nothing pic worthy has occurred.. I have been doing the wiring as I can for the last few days. Today I felT I made some real headway. I got all my Bus's( buses?) powered up under my console and got the VHF and FM radios powered off my accessory bus. I also got the antennas wired up and got to finally make some noise with these things! The VFH antenna I ended up with is 8 freaking feet high on top of a 4 foot console! Look out bridges !
I will take pics of my electrical work once it is all complete, otherwise yall might kick me off the board for showing such a mess.
An observation... for as simple and clean as I have tried to keep this, thereis a TON of stuff running from the transome under the floor up to the console:
Steering cable Throttle cable Gear cable Engine start controls Tilt/trim Aerator input and output hoses Bilge power Aerator power Power cable Stern nav light power Transducer ( not in yet arg) Fuel quantity sender
and probably something I am forgetting.. SHEESH!
I will hopefully have her water ready Tomorrow and hit the lake monday.
Still "to do"
Run transducer cable Connect tilt/trim hoses and ad fluid to system Finish electrical wiring Bolt down front seats Connect aerator hoses Change impeller in engine (is a bit weak on flow) Install 6 more rod holders Install nose cone Tighten steering wheel Bolt down floor Bolt in rear seat
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: Spud--Cattin Around Adventures]
#4955740
06/09/10 02:44 AM
|
Joined: Mar 2009
Posts: 559
Austintatious
OP
Pro Angler
|
OP
Pro Angler
Joined: Mar 2009
Posts: 559 |
Always leave em wanting more Ehh Ok so I haven't posted because well, Ive been too busy on the boat getting it ready for the water. The list in my last post was quite a chore to get done. I have however at this point had two sessions on the water. Lake date 1 Captains log: Felt a great rush as she pulled off the trailer. Great feel on the water. Engine is running really well! Full speed ahead to about 32 MPH... Notice a two large rooster tails behind the boat. 1 from the stair (accidentally left down) and one from transducer. Also notice a bad list to port at speed. Pull up stair, move 1 of my 250 lb friends to back and now 34 mph. We do a little fishing and then some tubein' just to put some miles on her and experiment. I realized the bilge pump wasn't working. A quick inspection found the wires hooked up wrong (would it really be so damned hard for them to just make the wire RED and black?) I did a MacGyver fix and went on my mary way. Battery is not happy. Permanently properly wired the bilge at home. Moved trim tab to help with list at speed. Also removed "whale tail" from motor. Day 2 (today) getting off trailer I forgot to remove transom saver...Ran the trim down for a sec and when I came to reality The damage was done and the UP would not work. Even at that with 1 less person, the half fixed transducer and removed whale tails and full nose down trim (exaggerated list) I was hitting 37 MPH.. I hope once I can trip UP I will be able to hit 40 mph. I cleaned her up a bit since we have been busy leaving finger prints and scraps everywhere... here are the pics.
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: Austintatious]
#4955808
06/09/10 03:00 AM
|
Joined: Nov 2009
Posts: 1,222
Chase Curtis
Extreme Angler
|
Extreme Angler
Joined: Nov 2009
Posts: 1,222 |
from someone who is doing the exact same job to almost the same boat (21' starcraft yr.88 hull) YOU HAVE DONE A GREAT JOB!
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: Chase Curtis]
#4957518
06/09/10 04:55 PM
|
Joined: Dec 2003
Posts: 3,180
2-stroke
TFF Team Angler
|
TFF Team Angler
Joined: Dec 2003
Posts: 3,180 |
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: 2-stroke]
#4957840
06/09/10 05:52 PM
|
Joined: Jan 2005
Posts: 7,491
redchevy
TFF Celebrity
|
TFF Celebrity
Joined: Jan 2005
Posts: 7,491 |
Looks great man. Awsome job now you just have to enjoy it and not get too upset from the dents and dings that will come with use.
matt
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: redchevy]
#4957873
06/09/10 06:01 PM
|
Joined: Apr 2007
Posts: 596
JSIG
Pro Angler
|
Pro Angler
Joined: Apr 2007
Posts: 596 |
Very nice brother. How much $ do you have in her now or expect to when complete? Bet you saved a small fortune doing it all yourself!
John 1998 Promaster 190V, Johnson 150
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: JSIG]
#4960512
06/10/10 03:28 AM
|
Joined: Mar 2009
Posts: 559
Austintatious
OP
Pro Angler
|
OP
Pro Angler
Joined: Mar 2009
Posts: 559 |
I had about 1500 In my old boat, I got it at a very good price and put some money and work into it. I have dumped about 2500 into this boat so far so All in all I have about 4k into it which includes: an $850.00 Side imaging fish finder/GPS All new floors new VHF radio 8' antenna and marine FM stereo All new stainless steel bolts New transom New impeller New aerator pump and lines New rod holders ( 10 of em!) New 7' Cast net New life jackets and whistles for each Fog horn New Oar New throw-able flotation New ski rings on transom. So all in all a pretty good deal! Today: I fixed my trim and got back onto the lake today... 41 MPH! yeehaw! I also caught some fish and slimmed her up! Buncha blue cats. Kept 3 for dinner
Last edited by Austintatious; 06/10/10 03:33 AM.
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: Austintatious]
#4960698
06/10/10 04:38 AM
|
Joined: Sep 2009
Posts: 4,800
FZ1
TFF Team Angler
|
TFF Team Angler
Joined: Sep 2009
Posts: 4,800 |
Stunning industry,man. You will go far.
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: FZ1]
#4960710
06/10/10 04:43 AM
|
Joined: Jul 2007
Posts: 7,154
opus
TFF Celebrity
|
TFF Celebrity
Joined: Jul 2007
Posts: 7,154 |
Great job now ya need to take it by the guy ya got it from and surprise him lol
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: opus]
#4965283
06/11/10 12:26 PM
|
Joined: Nov 2008
Posts: 1,935
Spud--Cattin Around Adventures
Extreme Angler
|
Extreme Angler
Joined: Nov 2008
Posts: 1,935 |
What no new exterior paint job? Just kidding, man what a project and I know you must be proud and you should be. BTW what lake do you fish?
|
|
Re: My restore proect...1983 Sea Nymph 191 Striper
[Re: Spud--Cattin Around Adventures]
#4965790
06/11/10 03:08 PM
|
Joined: Apr 2007
Posts: 2,165
Team Brown Stripe
Extreme Angler
|
Extreme Angler
Joined: Apr 2007
Posts: 2,165 |
It looks so good people that see it in person and hear the tale of all your hard work will find it hard to believe! WTG nice work!!!
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|