texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
ZX200_SOTW, World's Worst Fishing, D17, LostMyFish, DickeyMcD
119470 Registered Users
Top Posters(All Time)
TexDawg 123,153
hopalong 121,182
Bigbob_FTW 101,883
Bob Davis 91,564
John175☮ 86,107
Pilothawk 83,757
Mark Perry 73,883
Derek 🐝 68,439
JDavis7873 67,416
Forum Statistics
Forums59
Topics1,051,827
Posts14,184,608
Members144,470
Most Online39,925
Dec 30th, 2023
Print Thread
Page 8 of 17 1 2 6 7 8 9 10 16 17
Re: Trailer Bearings? [Re: Allison1] #2663604 09/22/08 10:00 AM
Joined: Sep 2008
Posts: 121,182
hopalong Offline
Pescador Loco
Offline
Pescador Loco
Joined: Sep 2008
Posts: 121,182
Mike halfmann the boatman has it right, thats exactly the way I have done all my bearings for 35 yrs. on many trailers and never had a problem except for blowing out the back seal on one by not paying attention to what i was doing. the best advise was the MYSTIC GREASE this is what the oilfield uses to lube rigs and if you think bearings take a beating think about 100,000# of pressure on a drill stem. mystic is by far the best grease and oil on the market. just my nickels worth of advice


" Hop, set the hook"!
hopalong 99,999
TexDawg 99,999
FJB! not my president by a long shot!

lake fork FISHERMANS COVE MARINA/reservations - 903 474 7479
Re: Trailer Bearings? [Re: Allison1] #2794778 11/03/08 09:01 PM
Joined: Oct 2008
Posts: 19
T
Texas Fishin Offline
Green Horn
Offline
Green Horn
T
Joined: Oct 2008
Posts: 19
I even have bearing buddies on my stock and utility trailers. I grease them at least every couple of months and it has been a lot of years since I have had bearing problems.

Re: Trailer Bearings? [Re: R_B_NITRO] #3126121 02/17/09 02:11 AM
Joined: Jul 2005
Posts: 430
R
redneck88 Offline
Angler
Offline
Angler
R
Joined: Jul 2005
Posts: 430
how do i check if the bearings are good or not on the trailer i just bought?

Re: Trailer Bearings? [Re: redneck88] #3142883 02/20/09 10:43 PM
Joined: Feb 2008
Posts: 90
R
redcatfish Offline
Outdoorsman
Offline
Outdoorsman
R
Joined: Feb 2008
Posts: 90
I've seen a lot of guys over grease their buddy bearings. If you keep adding grease and your seals are not leaking, sooner or later it's going to pop a seal. Visually inspect your wheels front and back side for grease leaks, that is the key. Once the seal is blown (OK waiting for a joke) water has a place to enter the hub. Also keep and eye on the full indicators on the buddy bearing cap.

Re: Trailer Bearings? [Re: redcatfish] #3152432 02/23/09 11:32 PM
Joined: Jul 2005
Posts: 430
R
redneck88 Offline
Angler
Offline
Angler
R
Joined: Jul 2005
Posts: 430
what do you mean by full indicators?thanks

Re: Trailer Bearings? [Re: redneck88] #3154154 02/24/09 11:48 AM
Joined: Feb 2008
Posts: 90
R
redcatfish Offline
Outdoorsman
Offline
Outdoorsman
R
Joined: Feb 2008
Posts: 90
It depends on the brand of buddy bearing. Some are a clear cap and you can see a plunger inside that has a mark you fill to. Some will have the grease zerk that moves as you fill and there will be a colored fill indicator. Hope this helps.

Re: Trailer Bearings? [Re: redneck88] #3195957 03/05/09 08:29 PM
Joined: Feb 2008
Posts: 519
M
MtM Offline
Pro Angler
Offline
Pro Angler
M
Joined: Feb 2008
Posts: 519
Originally Posted By: redneck88
how do i check if the bearings are good or not on the trailer i just bought?

You got to pull them. Check and see if they are deformed. That does not always happen if they are bad, but it does help.

Re: Trailer Bearings? [Re: MtM] #3203582 03/07/09 05:37 PM
Joined: Feb 2006
Posts: 673
S
sac-a-lait me Offline
Pro Angler
Offline
Pro Angler
S
Joined: Feb 2006
Posts: 673
Haha this post really is the winner of the oldest still posting post ! 2005-present lol.


fishing without beer is like,.umm...hunting without beer!
Re: Trailer Bearings? [Re: sac-a-lait me] #3206245 03/08/09 09:46 PM
Joined: Jan 2002
Posts: 27,130
Bazztex Offline
TFF Guru
Offline
TFF Guru
Joined: Jan 2002
Posts: 27,130
Originally Posted By: sac-a-lait me
Haha this post really is the winner of the oldest still posting post ! 2005-present lol.


I made it a sticky post to keep it at the top because of all the
trailer bearing questions and answers/ info are available in one thread.

Bazz fish


Re: Trailer Bearings? [Re: redneck88] #3206306 03/08/09 10:11 PM
Joined: Jan 2002
Posts: 27,130
Bazztex Offline
TFF Guru
Offline
TFF Guru
Joined: Jan 2002
Posts: 27,130
Originally Posted By: redneck88
how do i check if the bearings are good or not on the trailer i just bought?


One easy way is to wiggle the trailer by pushing on the sides and listen for a Clunk as the tires move side to side. Push directly on each wheel if you hear a clunking noise to identify the worn bearing.

Another is to jack up each side of the trailer and spin the wheels.. listen for unusual grinding noises... worn or loose bearings will give you an audible metal to metal conformation. Grab the tire and push in on the front and pull out on the rear side alternating from side to side. There should not be any slop in the hub side to side or pulling straight in and out.

When you remove the hub look for Blue or Brown Discolored and scored bearings.. that indicates a high heat condition. They should be shiny chrome/ silver in appearance when in good condition. Scoring or groves worn in the bearing rollers indicates metal loss either from the bearing cage,race or hub and the set should be replaced.

If you change the bearings yourself.. tighten the axle nut down until the hub is just snug with no in & outward movement then go to the next available hole and insert the cotter pin thru the slot in the castellated nut. Over tightening the bearings will cause failure. The bearings need room to expand as they heat up during travel but you don't want them loose either. It's best to check the hubs at the ramp and at home when you return home after your first couple of trips to make sure they are still snug. The Hubs should be warn to the touch but not hot.. excessive heat means you either have the axle nut too tight or you bearing grease has leaked out.. check you inboard hub seals for leaks.. if grease can get out... water can get inside the hub.

Bazz fish


Re: Trailer Bearings? [Re: Bazztex] #3299100 04/01/09 07:56 AM
Joined: Apr 2008
Posts: 586
8
83falcon Offline
Pro Angler
Offline
Pro Angler
8
Joined: Apr 2008
Posts: 586
ok great so sounds like we should all get a group together and have a class because I have no idea what im doing and im not even going to try and screw up that one laugh

Re: Trailer Bearings? [Re: Allison1] #3316177 04/06/09 12:31 AM
Joined: Nov 2006
Posts: 230
D
Dells Marine at Hubbard Creek Offline
Outdoorsman
Offline
Outdoorsman
D
Joined: Nov 2006
Posts: 230
I agree with this last post! Lots of info. Keep it simple to avoid problems in future!


DELLS MARINE specializing in boat repair New and used. Also Kawasaki Mule repair. Breckenridge Texas- 254-559-8333
-
Re: Trailer Bearings? [Re: Dells Marine at Hubbard Creek] #3324195 04/08/09 01:00 AM
Joined: Mar 2004
Posts: 619
L
lysdectic Offline
Pro Angler
Offline
Pro Angler
L
Joined: Mar 2004
Posts: 619
Need a how to with pictures.I"m not a mechanic but willing to learn how to do this.

Re: Trailer Bearings? [Re: lysdectic] #3340072 04/12/09 05:18 AM
Joined: Jan 2002
Posts: 27,130
Bazztex Offline
TFF Guru
Offline
TFF Guru
Joined: Jan 2002
Posts: 27,130
OK.. Just ask and I'll try to find it for you.

I found a link with Pictures to illustrate each step for changing trailer bearings! thumb

http://www.etrailer.com/faq_wheelbearingpack.aspx

Enjoy cheers

Bazz fish

Re: Trailer Bearings? [Re: Bazztex] #3342894 04/13/09 03:20 AM
Joined: Aug 2008
Posts: 1,725
C
Capt'n Wings Offline
Extreme Angler
Offline
Extreme Angler
C
Joined: Aug 2008
Posts: 1,725
tHANKS A BUNCH FOR THE WEBSITES . nOW THAT'S AN EXAMPLE OF HOW A FORUM CAN REALLY BE OF HELP TO PEOPLE. i'VE PRINTED THE INSTRUCTIONS FROM BOTH THE SITES MENTIONED AND AM CONFIDENT i CAN NOW TEND TO MY BEARING NEEDS. i'VE BEEN WORRYING ABOUT IT LATELY BECAUSE i KNOW i'M OVERDUE TO TEND TO THEM.


"Faith requires one to elevate the practice of not thinking to a virtue," Mark Twain
Page 8 of 17 1 2 6 7 8 9 10 16 17
Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3