Sneak peek at a brand new style of Mad Katz grips coming out in March. Sticky grips.

I’ve got 15 MH whisker seekers that I would gladly trade for rods that didn’t constantly rock in my smack down rod holders…… I’ll make someone a heck of they’re interested.

Well, I haven't wet a hook since the first weekend of November, so I went into the garage and sure enough there are two nuts to seat the reel. But the complaint remains the same, they still came loose until I wrapped them with electrical tape. What I don't have is the washer. No big deal. If I wasn't forced to sink a ton of cash this winter into replacing my transom I was going to go back to Louisville again next month and probably buy 2 more. I ordered two sets of Raptor Racks for the boat and each one holds three rods.

Oh, dude just run that first nut on up snug by hand, then that jam nut, and you pull that up tight against the first one and you pull it tight with like channel locks, but with like a piece of canvas strap around the reel seat nut, that way, you get no pecker tracks on your rod and more importantly right where your hand goes sometime. You do that dude, your golden with that setup. Oh, yes the tape works too, I just always messing with it as the end is always trying to come up and get off.

those new grips look good