Bump

i need help picking a battery. what kind of battery are you guys using for you bass hunters? I have a 30lbs trolling motor and a small fish finder a lowrance elite 4 HDI and that it. In the future I want to put lights for night fishing. I want my battery to run a long time with all the electronics on it, I was looking at this one http://www.academy.com/shop/pdp/exide-stowaway-marine-rv-deep-cycle-battery/pid-825857?N=126241233

I have a " regular" gel trolling motor battery that I bought at BPS. Actually, I bought 2, but have NEVER needed the second one, even for an all-day trip in high wind.

All of the campuses where I teach at on spring break this week and next week so I think I'm going to try to hit the water a few times. Anyone interested in meeting up holler.

You lose my number dude!?

Hit me up.

I can fish tomorrow and Sunday. Send me a PM after you call D.B.

I have a 8ft bass raider. I use to only use a minkota 30lb thrust but i recently picked up a 1.5 Cruise And Carry that really pushes the boat and creates a nice wake while doing so. I've learned to ride choppy water if i get stuck out after the wind picks up and feel ten times more safe in this boat then i have in 12ft John boats I've been in. Standing up has never been a problem. Best part is when big fish takes you for a ride lol! Good times. I never knew this may people have these little boats.

What is the best method for attaching tx numbers to the hull of a bass hunter ex?

you can spread a bit of clear goop glue around the edges of the numbers. I think that is what I dd.

You for sure need to use something like timbertoes said because I have an EX and have had the numbers fall off.

Yea that's right. Mine fell off on one side, so I'm glad this question was asked.

Not sure on that one. Mine were already on when I bought it. I would assume that a little epoxy thinned down and painted over them would do the trick though.

Long time no see David! Hope your well bud.

The EX is made of some really high tech kind of plastic that NOTHING will stick too.

I ended up tracing them on with a really thick sharpie marker. They fade after 8-10 trips and I have to go over them again.

I tried to use the spray glue from 3M that the manufacturer recommended but it was wayyyy to messy and a pain.

Yes, I haven't been on hear lately Dan aka DB Cooper. I am doing great but haven't been fishing in months. All the ponds close to me have about 1 inch visibility The last 2 times I went out I got nothing.

My numbers seem to stay on fine but my registration stickers are a different story. I've used hot glue and it kind of works but I'm close to losing one of them if I don't find another fix.