|
Forums59
Topics1,040,450
Posts13,981,686
Members144,238
| |
Most Online39,925
Dec 30th, 2023
|
|
 bleeding tilt and trim on 1992 Mercury 200
#3662226
07/07/09 02:28 AM
|
Joined: Jul 2008
Posts: 80
lobobass
OP
Outdoorsman
|
|
OP
Outdoorsman
Joined: Jul 2008
Posts: 80 |
Does anyone know how? Need detailed steps for not so smart boat owner. Thanks
|
|
|
Re: bleeding tilt and trim on 1992 Mercury 200
[Re: lobobass]
#3662610
07/07/09 03:50 AM
|
Joined: Jun 2004
Posts: 1,509
OPTI
Extreme Angler
|
|
Extreme Angler
Joined: Jun 2004
Posts: 1,509 |
LOBO..... Here ya go TO FILL:
IMPORTANT: This trim system is pressurized.
Remove Fill plug only when outboard is tilted
to the full Up position or the trim/tilt rams are
fully extended. Retighten Fill plug before tilting
outboard down or retracting tilt/trim rams.
Remove Fill plug and O-ring. System is full
when oil level is present at fill hole. Tighten Fill
plug securely.IMPORTANT: Run Trim System in short jogs
until pump is primed and trim system moves. If
trim motor is run without priming pump, driveshaft
failure could result.
Cycle outboard through entire trim/tilt range 4 times.
Check fluid level after purging system.
Push down on outboard when trim rams are slightly
extended. If rams retract more than 1/8 in. (3.2 mm),
air is present in system. Cycle system again and
check fluid level.......OPTI
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
