Brand new TM, remote spot lock feature functions, foot pedal button does not. Paired with the white hockey puck on the boat, pedal sits on top of the deck so no interference with the button, batteries load tested and no big volt drop from batteries to TM. I can and will take it to an authorized service center if need be just wondering if I am not doing something simple that I am supposed to.

Are you checking it while stowed? It has to be at least partially deployed. Or did you mean just the spot lock isn’t functioning?

Deployed spot lock not functioning when pressing the anchor button on the pedal. It works when pressed on the remote.

Paging Steez.

If the remote works then it’s most likely the magnetic switch. Sometimes they just need to be adjusted a little bit

Bingo….or the ribbon wires under the metal tray, between the metal tray and plastic base of the foot pedal, are pinched. There’s like 14-15 No6 panhead screws to remove and 2 small machine screws.

Likely around 98% tmd11111 is correct.

So the button to make it go doesnt work or the anchor button doesnt work?

Thanks guys, when I get a minute this week I will open that foot pedal and see if I can adjust the switch.

take it over to Allstar and they will get to it around May 3rd

Finally got a chance this evening to check out the foot pedal as suggested above. Found some pinched wiring and adjusted the position of the board and the pedal is now working as it should! Thanks guys I really appreciate the help!!!

That will work!