texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
BX19gti, Likesfishing, db89, OlePhart11, Rick P
119199 Registered Users
Top Posters(All Time)
TexDawg 119,880
Bigbob_FTW 95,524
John175☮ 85,945
Pilothawk 83,279
Bob Davis 82,755
Mark Perry 72,532
Derek 🐝 68,324
JDavis7873 67,416
Forum Statistics
Forums59
Topics1,039,302
Posts13,962,547
Members144,199
Most Online39,925
Dec 30th, 2023
Print Thread
johnson/evinrude mechanics #11649625 06/06/16 01:07 PM
Joined: Sep 2008
Posts: 121,172
hopalong Offline OP
Pescador Loco
OP Offline
Pescador Loco
Joined: Sep 2008
Posts: 121,172
need your opinion here.

96 faststrike bogging
finally got to run the boat some, here are the symptoms.

starts and idles fine, will run up with the hotfoot fine in neutral.

let it warm up while I parked the truck and total it idled was about 5 mins. before I took off so the engine was warm.

got on plane fine, ran up to 5800 rpm fine and ran about 3/4 of a mile then the bogging started again, just loses power but does not die if I put it in N then it idles fine again.

let it sit and fished some, about an hr. then tried again, same result.

while idling back to the ramp (hopefully to avoid possible damage) I tried my choke, pushed the key in and the engine promptly died/flooded, started again and let idle a min or so then again pushed the key and it died, this time it took 5-6 attempts to restart but did when the cyls. cleared.

what do y'all think? I am leaning toward a power pack going out (believe the one I put in a little over a yr ago is a cdi unit). voltage shows good and the stator (oem) is pretty new so don't think that is a concern.


really don't want to toss parts at it and will take to a mech if needed but prefer to hear the diagnostic wizards on here. thanks in advance.

Last edited by hopalong; 06/06/16 01:53 PM.
Re: johnson/evinrude mechanics [Re: hopalong] #11650641 06/06/16 09:46 PM
Joined: May 2003
Posts: 11,586
gary purdy Offline
TFF Guru
Offline
TFF Guru
Joined: May 2003
Posts: 11,586
Have had a lot of problems Hop with those blankady blank plastic carbs on these motors dripping fuel in the venturi`s. They become warped. Look down the throats while running. Gas it and if bad you will see fuel come out the front of the carb. The other possibles are you are down a cylinder because of a power pack or coil. Check to make sure the timming roller hasn`t backed off of the throttle arm on top. Up here: http://www.boats.net/parts/search/BRP/EVINRUDE/1996/SE150WTPXB/THROTTLE%20LINKAGE/parts.html


The world will not be destroyed by those who do evil, but by those who watch them without doing anything. Remember what He has done and remember that He is not done yet!-- GOD IS GOOD
Re: johnson/evinrude mechanics [Re: hopalong] #11653279 06/08/16 01:27 AM
Joined: Jan 2009
Posts: 1,650
S
spankyttx Offline
Extreme Angler
Offline
Extreme Angler
S
Joined: Jan 2009
Posts: 1,650
i've seen an elect fuel pump do that, a weak pump will run fine at idle to low but may not be able to keep up at wot, just a thought


LI-SI-WI-NWI
Re: johnson/evinrude mechanics [Re: hopalong] #11660139 06/11/16 03:23 AM
Joined: Oct 2014
Posts: 495
C
ctapp Offline
Angler
Offline
Angler
C
Joined: Oct 2014
Posts: 495
Hop can u send me a pic of your motor with the mr gasket pump mine just went out 96 175 intruder mine did tht to had to sand down one of the bowls to seal it an replaced another thnks hop


Pro staff//
Guns n Clubs
GAMBLER Lures
Duckett fishing
Re: johnson/evinrude mechanics [Re: spankyttx] #11661406 06/12/16 01:09 AM
Joined: Sep 2008
Posts: 121,172
hopalong Offline OP
Pescador Loco
OP Offline
Pescador Loco
Joined: Sep 2008
Posts: 121,172
Originally Posted By: spankyttx
i've seen an elect fuel pump do that, a weak pump will run fine at idle to low but may not be able to keep up at wot, just a thought



spanky wins this round, fuel filter was messed up and pump was not keeping up, all fixed now.

Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3