Texas Fishing Forum

Dang Rod Tubes

Posted By: bassnman

Dang Rod Tubes - 12/30/21 06:56 PM

Anybody know how to take the rod tubes out of a Phoenix? I cant see where any screws are. I have a 920 Pro XP.
Posted By: 361V

Re: Dang Rod Tubes - 12/31/21 01:33 AM

You ask Phoenix? https://phoenixbassboats.com/contact-us
Posted By: bassnman

Re: Dang Rod Tubes - 12/31/21 02:00 AM

Not yet, but I will. Thx.
Posted By: KnotTexan

Re: Dang Rod Tubes - 12/31/21 03:13 AM

Should be three phillips screws across the top, above the tubes to remove. It may be a little jammed, so you might have to give it a good pull to get it out.
Posted By: tmd11111

Re: Dang Rod Tubes - 12/31/21 11:19 AM

Would love to help you but when I bought my 920 this past summer the previous owner already had removed them. Didn't even bother to ask if he still had them.
Posted By: bassnman

Re: Dang Rod Tubes - 12/31/21 04:39 PM

Originally Posted by KnotTexan
Should be three phillips screws across the top, above the tubes to remove. It may be a little jammed, so you might have to give it a good pull to get it out.

Thx, I will take another look.
Posted By: bassnman

Re: Dang Rod Tubes - 01/01/22 05:02 PM

Turns out 2 Philips screws but not on top where I was looking. They were on the back near the top going horizonally toward the front. Very easy to remove and pull the tubes. I now have tubes and butt end holders out. Got 15 rods in there and it looks almost empty. Love it so far.
© 2024 Texas Fishing Forum