Texas Fishing Forum
Help...cant get prop back on after repair
Posted By:
gut hooked
Help...cant get prop back on after repair -
11/04/17
11:09 PM
Spun the hub....got it repaired, picked it up, cant get it back on. Take a look, comments welcome
Posted By:
gut hooked
Re: Help...cant get prop back on after repair -
11/04/17
11:10 PM
It doesnt seem like the prop is down far nough on the shaft....there is a gap berween the bottom of the prop and the motor base.
Posted By:
Bruce's
Re: Help...cant get prop back on after repair -
11/04/17
11:30 PM
were is the washers. Is that a solid hub take it back off and take a pisture
Posted By:
gut hooked
Re: Help...cant get prop back on after repair -
11/04/17
11:40 PM
Ok. I will. Thanks.
Posted By:
2014NITROZ-7
Re: Help...cant get prop back on after repair -
11/05/17
12:38 AM
Check the thrust washer is turned beveled side down.
Posted By:
bradnitro175
Re: Help...cant get prop back on after repair -
11/05/17
01:20 AM
Hammer and a block of wood make sure the splines are lined up.put it in gear if you have to
Posted By:
Jimfishes
Re: Help...cant get prop back on after repair -
11/05/17
01:29 AM
Looks like it needs to be turned by hand to line up splines...then it will slide on in.
Posted By:
gut hooked
Re: Help...cant get prop back on after repair -
11/05/17
01:57 AM
Thanks for the help. Going to the shop just in case. It seems to be beyond my limited mechanical knowledge base.
Posted By:
Flippin-Out
Re: Help...cant get prop back on after repair -
11/05/17
08:16 AM
Originally Posted By: Ol Man River
Looks like it needs to be turned by hand to line up splines...then it will slide on in.
I think you just hit the propshaft square on the end....hope you used a rubber mallet, lol.
Posted By:
grout-scout
Re: Help...cant get prop back on after repair -
11/05/17
01:29 PM
Did you at least put grease on it?
© 2024
Texas Fishing Forum