HPDI Mechanic

I have an '06, 200HPDI, new powerhead last February and has been running fine. I don't get a ton of time on the water, but put some hours on it in March. Followed the break in instructions to the T!! Last 2-3 times I have gone out it dies while idle. Shift into gear and it runs fine. Recently done service, new belt, new VST filter/seal, high pressure filter, main fuel filter, both low pressure pumps, plugs and even changed the primer ball. Ball never went soft though, just did it because. Fires up like a champ, then dies after about 5-8 seconds. I will be doing a compression check today but can't see how that would be it since it is new. But you never know.

Looking for someone around the South DFW Metroplex preferably, but many people I have called are like 6-8 months out, so just let me know if you can get it in any sooner. I did send the guy that did the power head for me a message, but haven't heard back.

Thanks in advance,

Jake

we can check it out were about 2 weeks out

PM sent