A friend of mine has a 1996 Skeeter 180 (I think). His front seat bushing is worn out and his seat "wobbles" quite a bit. Is this something that can be fixed/replaced? If so, how?
No ones had this problem?
Posted By: ssmith
Re: 1996 Skeeter Seat Bushings - 08/10/19 07:43 PM
if it is the brass one take a chisel an cut the top off use the new one to drive it down the hole
It is brass. Do you know where to get a new one?
Posted By: dobbin
Re: 1996 Skeeter Seat Bushings - 08/11/19 10:03 PM
Raise the front compartment door. pull the plastic box out by removing several screws which hold it in place. Underneath the deck you will find a bracket that is held in place by 2 1/2 headed bolts remove them and replace the brass bushing. May be hard to find but one can be made out of brass stock.
Posted By: ssmith
Re: 1996 Skeeter Seat Bushings - 08/12/19 03:46 AM
swivel ease part no 587987 is the brass insert much easier to take a chisel cut the flange off the top an drive the new one in with a dead blow hammer. if you cant find one i have them pm me