Texas Fishing Forum

ECM Fried??? 2002 Mercury EFI 200 2.5L

Posted By: DillonCan'tFish

ECM Fried??? 2002 Mercury EFI 200 2.5L - 05/31/18 04:30 PM

Trying to help a buddy get his boat fixed after it randomly died on him idling out of a cove. Now he has no spark at any of the cylinders. It was running just fine, then it just went off. No sputter or anything, just off. This guy is a stickler when it comes to maintenance and the boat hasn't had so much as a hiccup since he got it.

2002 Mercury 200 EFI 2.5L

Checked stop circuit including ignition switch, neutral & kill switch. All good. Plenty of oil. All fuses on side of motor are good.

-Key to on: No beep. No fuel pump. Dash lights come on.
-Key to on and wait 10 seconds: Sounds like fuel pump kicks on and solid alarm sounds. Alarm and pump stays on until key is turned off. Fuel will continue to prime for a few more seconds after key to off and then stops.
-Key to crank position: Engine turns over but has no spark. Tach is getting a reading during cranking.

Took it to a mechanic that said he would scan it for him at no charge. Scan tool won't connect. Told it was probably a bad ECM.

Is there anything else we can check before he starts throwing parts at this thing? I have no reason to doubt the mechanic, I just want to check everything we can before he shells out that kind of coin.
Posted By: Micheal

Re: ECM Fried??? 2002 Mercury EFI 200 2.5L - 05/31/18 11:57 PM

Listen to your mech.
The ECM for that motor is no longer available.
Best chance is to get that on repaired if possible.
Posted By: dan805

Re: ECM Fried??? 2002 Mercury EFI 200 2.5L - 06/05/18 11:33 PM

same thing happened to me last year. Sent my ECM to Simon Motorsports these folks as I was told they are the best. I agree they are very good, did a great speedy job.


Dawn
Simon Motorsports/Simon Performance Technology
1900 Joe Crosson Drive
El Cajon, CA 92020
760-440-9334
© 2024 Texas Fishing Forum