Both of my livewell actuators are out on my Skeeter. First time this happened I went all Mr Fix it and replaced the O-rings and Cut and drilled 1/8" all-thread to the slide gate to make them work. Well fast forward 10 years later and the all-thread has finally given it up.

Called Flow-right and they don't just sell the actuators. You have to buy a whole pump out kit ($50 each). (kinda expressed how stupid that was)

Anyone know of anywhere that may stock Flow-rite parts without going to them direct.

I have some stuff and can get anything

About to give ya a call

I need to replace both of mine, guess I’ll get to that this winter at some point.

Classic Fiberglass.. So you can get the rubber flap valves that go inside? My rubber fell apart. I have been using a drain plug to keep the water in the live wells.

I have to use the livewell plugs as well, and even with them in I still get about it a 1/4 - 1/2 a tank of water in my wells just from running around.

Oh i gave up on the drain valves a long time ago. Must have replaced the flappers 2-3 times over the years Just running the basic plugs from inside the livewell.

What im needing is the pump out actuator nozzle. Its the nozzle you pull forward when in recirc to change it to pump out. If you have ever pulled them a part before you will see there is a little spine that goes to a slide gate that slides up between the double hose connection off the back that redirects the water to the pump-out tube. That little gate has broken off. One is stuck in recirc only (which is fine) But the other one i took apart and pulled the broken gate out, and now its doing both recirc and pumping out since there isn't a close off. (rednecked it up with a plug in pump out thru hull fitting to get by for now)