texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
xHAWGZx, bfstackledirect.com, NTX.VEN, JSL219, Bird78
119082 Registered Users
Top Posters(All Time)
hopalong 120,088
TexDawg 119,194
Bigbob_FTW 94,509
John175☮ 85,862
Pilothawk 83,248
Bob Davis 80,538
Mark Perry 71,961
Derek 🐝 68,279
JDavis7873 67,416
Forum Statistics
Forums59
Topics1,036,385
Posts13,910,526
Members144,082
Most Online39,925
Dec 30th, 2023
Print Thread
225 EFI help #13822219 12/28/20 06:27 PM
Joined: Oct 2012
Posts: 118
O
otrdriver2002 Offline OP
Outdoorsman
OP Offline
Outdoorsman
O
Joined: Oct 2012
Posts: 118
Hi I just bought a used 98 225 EFI with no compression on #6 to used as a parts motor for my 95 225efi. After swapping lower units and putting a new water pump I am getting GOOD flow out the pee hole but NO water out the pressure gauge hose. On the muff or in the tub at idle or 2000 rpm. Hose is not plugged as I can blow back through it.
It should flow water when running in a tub shouldn't it?


Best todate 12.03 Clyde Lake. 1995 Elite 202 Champion still floating.
Re: 225 EFI help [Re: otrdriver2002] #13822416 12/28/20 10:25 PM
Joined: Sep 2008
Posts: 120,088
hopalong Offline
Pescador Loco
Offline
Pescador Loco
Joined: Sep 2008
Posts: 120,088
are you letting it run till warm enough to open the poppets?

is it a deep tub or a 12" wash tub type, need to be sure the water is not being aerated by the exhaust or it will suck air a lot.

have you put it in at a ramp and run it? might try that next if not.


" Hop, set the hook"!
hopalong 99,999
TexDawg 99,999
FJB! not my president by a long shot!

lake fork FISHERMANS COVE MARINA/reservations - 903 474 7479
Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3