|
Forums59
Topics1,037,854
Posts13,935,662
Members144,150
|
Most Online39,925 Dec 30th, 2023
|
|
Re: Hummingbird solix 12 SI and DI help
[Re: tmd11111]
#13733026
10/16/20 02:40 PM
|
Joined: Oct 2014
Posts: 452
ACES82
OP
Angler
|
OP
Angler
Joined: Oct 2014
Posts: 452 |
Looks like a good starting point. Now taker her out and see how it does. Soon as I can get to my boat I'll take a pic to show you a little trick to reduce the spray off of it. Thanks. Hopefully i can get on the water a little sunday without being blown off.
Never Outsmart Common Sense.
|
|
Re: Hummingbird solix 12 SI and DI help
[Re: ACES82]
#13733424
10/16/20 09:09 PM
|
Joined: Apr 2017
Posts: 11,977
tmd11111
TFF Guru
|
TFF Guru
Joined: Apr 2017
Posts: 11,977 |
Ok I said I owe a pic. Here’s my totalscan transducer. As mounted it reads great up to 50mph which is as fast as my boat goes. Problem was the spray off of it was really bad. The green plastic is a piece of cheap disposable cutting board. Cut it out and put it on there over 3 years ago and works great. No more spray. I probably could trim some off the back end but never got around to it.
|
|
Re: Hummingbird solix 12 SI and DI help
[Re: ACES82]
#13734050
10/17/20 02:11 PM
|
Joined: Oct 2014
Posts: 452
ACES82
OP
Angler
|
OP
Angler
Joined: Oct 2014
Posts: 452 |
Thats pretty neat. Need to go find a disposable cutting board now. How did you get it to stick to the transducer?
Never Outsmart Common Sense.
|
|
Re: Hummingbird solix 12 SI and DI help
[Re: ACES82]
#13734057
10/17/20 02:18 PM
|
Joined: Apr 2017
Posts: 11,977
tmd11111
TFF Guru
|
TFF Guru
Joined: Apr 2017
Posts: 11,977 |
Thats pretty neat. Need to go find a disposable cutting board now. How did you get it to stick to the transducer? It's sandwiched between the transducer and mounting bracket. Just cut it out and mark where the holes are and cut or drill them out.
|
|
Re: Hummingbird solix 12 SI and DI help
[Re: tmd11111]
#13734214
10/17/20 06:05 PM
|
Joined: Oct 2014
Posts: 452
ACES82
OP
Angler
|
OP
Angler
Joined: Oct 2014
Posts: 452 |
Thats pretty neat. Need to go find a disposable cutting board now. How did you get it to stick to the transducer? It's sandwiched between the transducer and mounting bracket. Just cut it out and mark where the holes are and cut or drill them out. Wasnt sure about that, thanks for the tips. Ill let you know how the new setup works, hopefully i can get out tomorrow some for some channel cat hunting.
Last edited by ACES82; 10/17/20 06:13 PM.
Never Outsmart Common Sense.
|
|
|
|
|