Was on the water today and noticed i had no sonar on the bow elite 9 ti2 hooked to the ultrex us2. Never had an issue until today. I took off connections and noticed one of the pins on the us2 adapter cable was bent a little, i straightened the pin out and reattached correctly and still no sonar. the sonar has a line on the top like its running but nothing else but a blank white page. I tested continuity on the cable and adapter cable. any help is appreciated

FIRST look to make sure your SONAR is looking at THIS UNIT as its SOURCE. Try doing a RESET SONAR DEFAULTS if that did not help.
To find Source, go to SONAR only screen, make sure your menu is showing on right side and see if there is a SOURCE selection and make sure it states This Unit.

Thanks Rob, sorry I haven’t answered in a few days been busy at the fire station, I’ll be on the water in the morning and I’ll try your recommendations if it doesn’t work I’ll call you when I’m done with tournament hours. Thanks again for all you do for us on this page.