After going through 3 Skeeter ZX225 cooler lids I switched to the FX lid. The cup holder came as a separate piece. Wonder if anyone who has an FX can tell me how their cupholder is mounted to the lid.

Thanks,
Joe

2 screws

Only reason I know is because I lost the first set of cup holders I had after adding to my ZX, dealer didn’t screw them down.

Most only go thru the cooler lid from being too rough with them.

Zx cooler lid is junk

So is the old (pre 2017) FX Cooler Lid!

Thanks Minner Bucket! Are those screws or do they have lock washers underneath?

Only screws, just eye ball and make sure you have plenty of glass to screw into. Dealer sent me those screws with the cup holder. Weidas marine.

Underneath the cup holder is 2 spots for screws also but I didn’t do that, just the 2 on top

Thanks Minner

YW, much better than the ZX garbage, just wish Beorne Marine would have secured the cup holders when they installed. Those cup holders by themes are hard to find.

Lol, they gave it to me in 2 pieces when I picked it up the other day

For those that have changed their Zx lid, what is the difference? I have a 2016 Zx225 and have thought about replacing mine but it hasn't broke yet. Thanks.

SkeeterK, I have a 2010 and the lid is hard plastic and the hinge is made of plastic. I have broken three lids. The FX lid open from front to back, has a metal hinge and the seat itself is a rubber coated cushion instead of hard plastic

I have a 2011 ZX200...You didn't have any issue with installing the FX lid, did you? I didnt know if there was any trouble with the older models. I've been looking to make that upgrade.