texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Goodtogo, BenBarber, R Garison, Bobthephysicist, FJH
114091 Registered Users
Top Posters(All Time)
TexDawg 98,570
Pilothawk 80,525
John175☮ 77,864
Bigbob_FTW 68,919
JDavis7873 67,400
Derek 🐝 65,509
Mark Perry 61,373
Tritonman 59,010
facebook
Forum Statistics
Forums62
Topics1,135,329
Posts15,477,592
Members139,091
Most Online36,273
Jan 23rd, 2013
Print Thread
Motorguide tour digital 36volt help #13645283 07/26/20 08:23 PM
Joined: Apr 2017
Posts: 118
D
Diaudioman Offline OP
Outdoorsman
OP Offline
Outdoorsman
D
Joined: Apr 2017
Posts: 118
I purchased a new to me motorguide tour digital 36volt about 3 months ago. It worked great the first few times I used it. Then it would occasionally stop working and then start again and work for a while. Then about 3 weeks ago it stopped all together so I checked all of the connections they all tested perfectly. So I pulled the lower unit apart and it had 36volts at the brushes when turned on. So I checked the impedance of the armature. It was all in range. So I cleaned the commutators and replaced the brushes. And after assembling it. It seemed to work fine. So I went fishing this morning and it wouldn't work at all. So I got back into the lower unit and now there is no power at the brushes but power on the power input side. What would be the next logical step to diagnose the problem. Any input would greatly be appreciated. Thanks

Re: Motorguide tour digital 36volt help [Re: Diaudioman] #13645550 07/27/20 12:15 AM
Joined: Apr 2017
Posts: 118
D
Diaudioman Offline OP
Outdoorsman
OP Offline
Outdoorsman
D
Joined: Apr 2017
Posts: 118
Does any one know of a good method of checking the se module?

Re: Motorguide tour digital 36volt help [Re: Diaudioman] #13685671 08/30/20 11:52 PM
Joined: Apr 2017
Posts: 118
D
Diaudioman Offline OP
Outdoorsman
OP Offline
Outdoorsman
D
Joined: Apr 2017
Posts: 118
I purchased a new to me 36v tour digital trolling motor about 4 months ago. It worked fine the first 5 or 6 times I went out. Then it stoped working occasionally and then just stopped altogether. I thought i had a bad se module(because I would leave it on during charging) so I replaced it and the brush card. And now when you turn the switch on the motor kicks on for about a 1/2 second then nothing happens. I have 38.381 volts at the motor head on the red and black wires even when I flip the switch on. I have made a jumper to jump from battery wires to the head and this did not help. Then I tied the orange and green wire together temporarily to see if it would run on high. Still nothing. What would be the next logical step to troubleshoot this problem? Any help would greatly be appreciated.

Previous Thread
Index
Next Thread

© 1998-2019 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3