texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
tkennedy58, Senko9L, xrayfoxtrot38, Nitro Blast, theXxar
112017 Registered Users
Top Posters(All Time)
TexDawg 92,789
hopalong 83,613
Pilothawk 79,331
John175☮ 75,257
JDavis7873 67,398
Derek 🐝 63,712
Bigbob_FTW 62,044
Tritonman 58,834
Mark Perry 58,468
facebook
Forum Statistics
Forums62
Topics770,022
Posts9,698,317
Members112,017
Most Online36,273
Jan 23rd, 2013
Print Thread
Evinrude Tilt and Trim #13389535 01/01/20 04:44 PM
Joined: Jan 2020
Posts: 2
R
rstex Offline OP
Green Horn
OP Offline
Green Horn
R
Joined: Jan 2020
Posts: 2
My 1984 Evinrude 150Hp tilt stopped working. It won't move either direction. Back story:
Went to winterize boat. Raised the outboard, later it was stuck in full up position. Lowered by Manual Release Valve. Fluid looked very "frothy". After checking fluid level and topping it off, fully charged battery, trim motor sounds fine in both directions.....It won't move in either direction.

I have since removed the pin, connecting it to the outboard, still no movement in either direction. I can release the MRV and move the tilt cylinder. As a side note I pushed the tilt cylinder all the way down, tightened the MRV closed. When I attempt to cycle the tilt system in the down position the tilt cylinder slowly creeps upwards??

I have seen where ppl say they "rebuilt" the system but only mention seals, o-rings etc. Is it not common to replace everything inside (assorted check valves etc)?

Also, as I was researching seals and o-ring kits I can not determine what type of tilt cylinder I have. I have looked for any type of numbers located on the tilt cylinder with no avail. I know it is supposed to have a P for Prestolite or S for Showa after the number

Attached Files trim.jpgboat model number.jpgResized_20181117_161202.jpeg
Re: Evinrude Tilt and Trim [Re: rstex] #13389565 01/01/20 05:14 PM
Joined: Sep 2010
Posts: 1,561
B
boatwhisperer Offline
Extreme Angler
Offline
Extreme Angler
B
Joined: Sep 2010
Posts: 1,561
sounds like its hydraulicly locked up/ it does happen to those units if not trailered correctly. there is a trick to repairing it that you can do. remove the valve that is located at the bottom left side of the unit but first put the engine on the tilt lock on the engine after you remove the valve put a 1/4 x 20 nut in the housing flat with the vale in the bottom of the opening and reinstall the balve that you removed. that will relieve the pressure on the valve. remove valve and the nut and reinstall the valve you may lose some fluid soo you may need to top off when finished


boatwhisperer
Re: Evinrude Tilt and Trim [Re: boatwhisperer] #13390283 01/02/20 12:01 PM
Joined: Jan 2020
Posts: 2
R
rstex Offline OP
Green Horn
OP Offline
Green Horn
R
Joined: Jan 2020
Posts: 2
i'll take a look at it tonight. thanks.

Previous Thread
Index
Next Thread


© 1998-2019 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3