texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
Packrattusnongratus, IMightKnowSomething, wesoftexas, Cruzcab, CWP70
111155 Registered Users
Top Posters(All Time)
TexDawg 91,580
hopalong 81,542
Pilothawk 78,598
John175☮ 72,738
JDavis7873 67,397
Derek 🐝 62,813
Tritonman 58,747
Bigbob_FTW 58,428
Mark Perry 56,518
facebook
Forum Statistics
Forums60
Topics758,977
Posts9,535,087
Members111,155
Most Online36,273
Jan 23rd, 2013
Print Thread
Gel coat hairline crack #13261570 08/27/19 06:04 PM
Joined: Feb 2006
Posts: 479
Alumacraft 14 Online Content OP
Angler
OP Online Content
Angler
Joined: Feb 2006
Posts: 479
I have 3 very small hairline cracks in the gel coat. They are the width of a hair about 1 to 1.5 inches in length and dont look to be deep. These cracks sit below the water line of the boat. Should I fix these or leave them be? My boat stays trailer in the garaged when being store. I believe these cracks happened due to a light impact from wave action against a wooden dock support. If I were to fix them I would be dremeling them out, filling with gel coat and sanding it down to a buff. I have done it before but only on much larger cracks.

Re: Gel coat hairline crack [Re: Alumacraft 14] #13262000 08/28/19 01:46 AM
Joined: Jan 2004
Posts: 2,180
R
rb7764 Online Content
Extreme Angler
Online Content
Extreme Angler
R
Joined: Jan 2004
Posts: 2,180
Fix them as you describe if they bother you. Otherwise, they are harmless.

Re: Gel coat hairline crack [Re: Alumacraft 14] #13262299 08/28/19 01:17 PM
Joined: Jan 2009
Posts: 1,435
S
spankyttx Online Content
Extreme Angler
Online Content
Extreme Angler
S
Joined: Jan 2009
Posts: 1,435
well heck, i guess i look at things a little differently. i don't see them as harmless, especially under the waterline. the gel-coat is the water proofer, fiberglass resin is not waterproof and does absorb moisture. i think cracks under the waterline would need to be sealed at the least


LI-SI-WI-NWI
Re: Gel coat hairline crack [Re: spankyttx] #13262663 08/28/19 05:40 PM
Joined: Apr 2004
Posts: 8,971
S
Stump jumper Online Content
TFF Celebrity
Online Content
TFF Celebrity
S
Joined: Apr 2004
Posts: 8,971
Originally Posted by spankyttx
well heck, i guess i look at things a little differently. i don't see them as harmless, especially under the waterline. the gel-coat is the water proofer, fiberglass resin is not waterproof and does absorb moisture. i think cracks under the waterline would need to be sealed at the least

You are correct that gel cost is the sealer but on a boat that is trailered the OP will never see a problem over the life of the boat. He probably would not even if it was stored in a marina in the water. I had my Ranger for almost 30 years. Over the time I owned it I got numerous chips and scratches on the bottom. Some received fairly quick attention and others did not. I am sure there were some under the bunk boards that I never saw. Never had any issues with the fiberglass at all.


2200 Bay Champ/200 Mercury Optimax
2017 Tundra TSS 4x4 Crewmax 5.7L
Re: Gel coat hairline crack [Re: Alumacraft 14] #13263009 08/28/19 10:31 PM
Joined: Nov 2002
Posts: 4,116
Gamblinman Online Content
TFF Team Angler
Online Content
TFF Team Angler
Joined: Nov 2002
Posts: 4,116
Most hairline cracks are through the clear gelcoat. There is a colored gelcoat below it that will act as a waterproofer Unless you see black, or red, or woven roving, you should be fine.

Re: Gel coat hairline crack [Re: Alumacraft 14] #13264250 08/29/19 11:05 PM
Joined: Jan 2004
Posts: 2,180
R
rb7764 Online Content
Extreme Angler
Online Content
Extreme Angler
R
Joined: Jan 2004
Posts: 2,180
My bad - I missed the below the waterline part. Yes, they need to be repaired then.

Re: Gel coat hairline crack [Re: Alumacraft 14] #13265376 08/30/19 08:52 PM
Joined: Jun 2015
Posts: 17
J
J IRWIN Offline
Green Horn
Offline
Green Horn
J
Joined: Jun 2015
Posts: 17
IF THE CRACKS ARE IN THE "ON PAD" OR "RUNNING SURFACE" YOU MAY WANT TO FIX. SOUNDS LIKE THEY ARE LIGHT FLEX CRACKS WHICH SHOULD ONLY BE IN THE GEL COAT SURFACE. YOU CAN GRIND ALL OF THE GEL COAT OFF THE BOTTOM OF A BOAT AND WATER WILL NOT AFFECT OR SOFTEN THE HARDNESS OF FIBERGLASS. I HAVE FIXED A LOT OF HOLDING TANKS THAT HAD NO GEL COAT. PLEASE FEEL FREE TO EMAIL ME PICS . jfiberglass@sbcglobal.net

Re: Gel coat hairline crack [Re: Alumacraft 14] #13268313 09/03/19 01:05 AM
Joined: Feb 2006
Posts: 479
Alumacraft 14 Online Content OP
Angler
OP Online Content
Angler
Joined: Feb 2006
Posts: 479
Thanks all. I went ahead and took care of them, they weren't deep. But I feel better knowing they are repaired.

Previous Thread
Index
Next Thread


© 1998-2019 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3