|
Forums59
Topics1,039,252
Posts13,961,581
Members144,197
| |
Most Online39,925
Dec 30th, 2023
|
|
 Motor lift switch
#13190834
06/20/19 01:51 AM
|
Joined: May 2018
Posts: 630
Ranger 177
OP
Pro Angler
|
|
OP
Pro Angler
Joined: May 2018
Posts: 630 |
Having problems lowering motor for transom saver no problems going up only down sometimes works sometimes doesnt. Any ideas. This is switch on side cowling
Last edited by Ranger 177; 06/20/19 01:52 AM.
|
|
|
Re: Motor lift switch
[Re: Ranger 177]
#13190884
06/20/19 02:50 AM
|
Joined: Apr 2004
Posts: 14,084
Stump jumper
TFF Guru
|
|
TFF Guru
Joined: Apr 2004
Posts: 14,084 |
I assume the switch at throttle works fine on down. If so down selenoid is probably good. Probably switch itself. Try bypassing and see how it works.
2200 Bay Champ/200 Mercury Optimax
2017 Tundra TSS 4x4 Crewmax 5.7L
|
|
|
Re: Motor lift switch
[Re: Ranger 177]
#13190971
06/20/19 10:16 AM
|
Joined: May 2018
Posts: 630
Ranger 177
OP
Pro Angler
|
|
OP
Pro Angler
Joined: May 2018
Posts: 630 |
Tilt trim at throttle does work fine. Only down on motor not working. Thanks for remarks
|
|
|
Re: Motor lift switch
[Re: Ranger 177]
#13194163
06/23/19 10:16 PM
|
Joined: Jun 2017
Posts: 328
Ripinlip
Angler
|
|
Angler
Joined: Jun 2017
Posts: 328 |
I had the same problem on my Mercury ended up just replacing the switch and now it works like new but I will say that they aint cheap 70-80.00$ is what I had to pay for a OEM
Cross Timbers Bass Club
|
|
|
Re: Motor lift switch
[Re: Ranger 177]
#13194167
06/23/19 10:24 PM
|
Joined: Oct 2012
Posts: 1,925
smooth move
Extreme Angler
|
|
Extreme Angler
Joined: Oct 2012
Posts: 1,925 |
my old yamaha did this too and i just pulled the cowling and sprayed the switch with contact cleaner, it started working fine. i then sprayed it again with corrosion x.
es le bon ton roulet
|
|
|
Re: Motor lift switch
[Re: smooth move]
#13194256
06/24/19 12:08 AM
|
Joined: May 2018
Posts: 630
Ranger 177
OP
Pro Angler
|
|
OP
Pro Angler
Joined: May 2018
Posts: 630 |
my old yamaha did this too and i just pulled the cowling and sprayed the switch with contact cleaner, it started working fine. i then sprayed it again with corrosion x. I will give shot. If not will replace switch like ripinlip stated. Thanks for comments
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
