Looking for some help or diagnosis direction. I�ve got a 2011 Yahama SHO 250 that wont crank when trimmed down? Anything below about a half inch of down trim and the motor wont crank. Any position above, it cranks & starts just fine. When trimmed down, turn the key, fuel pump turns on, all gauges on and nothing - no starter engaging or solenoid. Once started in the trimmed up position (which it will crank & start every time), I can trim down as normal and run as normal. I�ve check the wiring harness going from the hull to the motor, & connection points for loose connections/wiring. Could it be a bad neutral safety switch? Any help would be appreciated

had one like that it was on a skeeter with a hyd jack plate it put the main engine harness in such a bind that it pulled the hot wire in the harness nearly into an that is why it would only work in a certain position.

Appreciate the input - I�ve check the harness & the harness plug, twisted pull, & bent it around and it makes no difference?

Almost gaurantee you have a broken wire in the harness. Been there done that. Mine had exact same symptoms. Ended up being an ignition wire broken inside the insulation.

Update - Again, appreciate the input. Replaced the Yamaha rigging harness and problem fixed!