|
Forums59
Topics1,038,878
Posts13,954,690
Members144,181
| |
Most Online39,925
Dec 30th, 2023
|
|
 bleeding air / getting tilt/trim unit to work after service
#12780070
06/04/18 10:12 PM
|
Joined: Jul 2008
Posts: 3,022
joho5
OP
TFF Team Angler
|
|
OP
TFF Team Angler
Joined: Jul 2008
Posts: 3,022 |
Ok finally got all my seals on and figured it all out...upon reassembly, I cant get the unit to run right.
the relieve valve was open when reinstalling and when I got the unit put back on the boat, I tightened the valve and while the ram was full extended I filled up as much as I could.
it still wouldnt raise or lower, sometimes it would lower, but still havent got it to raise up.
Whats the process from a completely empty tilt and trim unit to get it to work again?
thanks
|
|
|
Re: bleeding air / getting tilt/trim unit to work after service
[Re: joho5]
#12780092
06/04/18 10:36 PM
|
Joined: Apr 2006
Posts: 1,029
dobbin
Extreme Angler
|
|
Extreme Angler
Joined: Apr 2006
Posts: 1,029 |
U tube is your friend....Add fluid release air....add fluid release air.... add fluid release air...Make sure the motor is up and locked as it will crash in the fluid is not full.....
Champion Jigs
|
|
|
Re: bleeding air / getting tilt/trim unit to work after service
[Re: joho5]
#12780581
06/05/18 04:55 AM
|
Joined: Jul 2008
Posts: 3,022
joho5
OP
TFF Team Angler
|
|
OP
TFF Team Angler
Joined: Jul 2008
Posts: 3,022 |
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|
