texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
TraeMartin, Power-Pole CS, T-Rigger, JoeGoes, EcKo
119150 Registered Users
Top Posters(All Time)
hopalong 120,585
TexDawg 119,524
Bigbob_FTW 94,903
Pilothawk 83,264
Bob Davis 81,523
Mark Perry 72,297
JDavis7873ฎ 67,416
Forum Statistics
Forums59
Topics1,037,854
Posts13,935,655
Members144,150
Most Online39,925
Dec 30th, 2023
Print Thread
Engine readouts on graph #12775303 05/31/18 02:12 PM
Joined: Mar 2018
Posts: 14
S
skeeter johnson Offline OP
Green Horn
OP Offline
Green Horn
S
Joined: Mar 2018
Posts: 14
hey guys
I am running a Yamaha 225 SHO and a lowrance 12 TI elite I have installed cable but still do not get trim, water psi,fuel level, what am I doing wrong? thx.

Moritz Chevrolet - 9101 Camp Bowie W Blvd, Fort Worth, TX - Monte Coon (817) 696-2003
Re: Engine readouts on graph [Re: skeeter johnson] #12775686 05/31/18 07:00 PM
Joined: Nov 2014
Posts: 23,176
S
SteezMacQueen Online Happy
TFF Guru
Online Happy
TFF Guru
S
Joined: Nov 2014
Posts: 23,176
I'm sure there are a lot of parts missing. Fuel level would require an integration harness of some kind, as well as trim, water psi, etc.


Eat. Sleep. Fish.
Re: Engine readouts on graph [Re: skeeter johnson] #12775739 05/31/18 07:50 PM
Joined: Feb 2017
Posts: 277
L
LakeTylerMan Offline
Angler
Offline
Angler
L
Joined: Feb 2017
Posts: 277
As I recall on the Gen 3 instructions trim needs to be set up by a dealer. I don't know why. For me it was not easy to choose the various functions to monitor. I was most concerned about getting a read out for engine hours. Call Lowrance and they may be able to walk you through it. They have been helpful when I called. They are first going to ask that you make sure software is up to date.

I had all kinds of problems getting certain readouts to show. The biggest challenge is remembering the steps to make it happen. Check Lowrance how to videos to see if this subject is covered. Having said all this, I have quite a few functions I can monitor.

Re: Engine readouts on graph [Re: skeeter johnson] #12776150 06/01/18 02:49 AM
Joined: May 2018
Posts: 9
O
OKBlindHogg Offline
Green Horn
Offline
Green Horn
O
Joined: May 2018
Posts: 9
I have a 250 SHO and Gen 3 HDS units. Trim involved hooking together different wires under the engine cowel . When you do your trim gage won’t work. Will just show on the graph. Water pressure was a water pressure sensor from Yamaha installed in the port where the water gauge hose port went into the block. I do t have fuel level but I also think it is a separate sensor on the tank

Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3