Forums59
Topics1,038,882
Posts13,954,768
Members144,181
|
Most Online39,925 Dec 30th, 2023
|
|
1996 Merc 115hp tilt/trim cylinder question
#12753787
05/13/18 09:46 PM
|
Joined: Jul 2008
Posts: 3,022
joho5
OP
TFF Team Angler
|
OP
TFF Team Angler
Joined: Jul 2008
Posts: 3,022 |
Sometimes at the top in between the shaft to the ram and the seal, it leaks a little bit.
How hard of a job is it to get the cylinder cap off and replace those seals?
Can I do this while leaving the whole unit on the boat? Or do I have to remove the entire tilt and trim assembly.
|
|
Re: 1996 Merc 115hp tilt/trim cylinder question
[Re: joho5]
#12753865
05/13/18 11:27 PM
|
Joined: May 2003
Posts: 11,586
gary purdy
TFF Guru
|
TFF Guru
Joined: May 2003
Posts: 11,586 |
Main problem is removing the piston in the cylinder so the rod will come out. Special tool for the cap.
The world will not be destroyed by those who do evil, but by those who watch them without doing anything. Remember what He has done and remember that He is not done yet!-- GOD IS GOOD
|
|
Re: 1996 Merc 115hp tilt/trim cylinder question
[Re: gary purdy]
#12754004
05/14/18 01:53 AM
|
Joined: Jul 2008
Posts: 3,022
joho5
OP
TFF Team Angler
|
OP
TFF Team Angler
Joined: Jul 2008
Posts: 3,022 |
Main problem is removing the piston in the cylinder so the rod will come out. Special tool for the cap. So I should prob take it somewhere?
|
|
Re: 1996 Merc 115hp tilt/trim cylinder question
[Re: gary purdy]
#12764808
05/22/18 01:43 PM
|
Joined: Jul 2008
Posts: 3,022
joho5
OP
TFF Team Angler
|
OP
TFF Team Angler
Joined: Jul 2008
Posts: 3,022 |
Main problem is removing the piston in the cylinder so the rod will come out. Special tool for the cap. Will a spanner wrench do the job getting the cap off? Could I just trim motor all the way up, drop the metal bracket that holds motor up, take out ram pin and bump out the rod that holds ram to motor, then unscrew the cap and lift ram up and out of cylinder? Then I could replace the leaking seal? Any and all help would be appreciate...thanks!
|
|
Re: 1996 Merc 115hp tilt/trim cylinder question
[Re: joho5]
#12779886
06/04/18 07:32 PM
|
Joined: Jul 2008
Posts: 3,022
joho5
OP
TFF Team Angler
|
OP
TFF Team Angler
Joined: Jul 2008
Posts: 3,022 |
Ok got the unit off, cap off, nowcant figure out how to take off piston or end of ram to replace cap seals.
Any help
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|