Forums59
Topics1,039,177
Posts13,960,410
Members144,192
|
Most Online39,925 Dec 30th, 2023
|
|
96 mercury 200 efi
#12375339
08/07/17 02:08 AM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
So i bought a boat with this motor. Took it out today and was running it. Was running wot and it shut off like i turned the key off. Would not start back just cranked and cranked.
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12375342
08/07/17 02:10 AM
|
Joined: Sep 2003
Posts: 5,519
Bruce's
TFF Celebrity
|
TFF Celebrity
Joined: Sep 2003
Posts: 5,519 |
Bruce's Sprinkler Repair 817-798-7246 52 years experience State Licensed Irrigation LI0017483
Fishing Texas lakes one at a time
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12375509
08/07/17 03:55 AM
|
Joined: May 2017
Posts: 136
TrailHand
Outdoorsman
|
Outdoorsman
Joined: May 2017
Posts: 136 |
If kill switch is OK, pull the spark plugs and look for metal flakes (bad news).
If none, you need four things for it to run.
Spark, suck, Gas, blow.
Start by checking the gas lines from one end to the other. Then check for spark on the cylinders, then intake, then exhaust.
|
|
Re: 96 mercury 200 efi
[Re: Bruce's]
#12375882
08/07/17 02:50 PM
|
Joined: Mar 2010
Posts: 25,824
T Bird
TFF Guru
|
TFF Guru
Joined: Mar 2010
Posts: 25,824 |
along with eng. and boat fuses.
Okie by birth, Texan by choice. USAF "Thunderbirds" Alumni 1985-1989
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12376021
08/07/17 04:30 PM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
Thanks, i will look it over.
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12376795
08/08/17 02:22 AM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
Ok i was looking at it tonight and on the head on the right side of motor is a sensor i believe it has a tan with blue wire going thru a jacket and the jacket melted. What i this sensor called i believe this is my problem it probably blew a fuse
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377040
08/08/17 10:20 AM
|
Joined: Nov 2006
Posts: 2,848
TLW
Extreme Angler
|
Extreme Angler
Joined: Nov 2006
Posts: 2,848 |
that's over heat sensor.. has nothing ta do with ignition and/or fuses.. if "any" jacket and/or wire is melted tha motor has gotten way to hot!.. ya need ta check tha warning buzzer for operation.. does it still have oil injection operating?
Last edited by TLW; 08/08/17 10:23 AM.
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377142
08/08/17 01:02 PM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
Yes it has oil injection. There was not any alarms at all.
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377144
08/08/17 01:03 PM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
Where is the alarm buzzer located ?
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377147
08/08/17 01:03 PM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
Where is the alarm buzzer located ?
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377152
08/08/17 01:08 PM
|
Joined: Nov 2006
Posts: 2,848
TLW
Extreme Angler
|
Extreme Angler
Joined: Nov 2006
Posts: 2,848 |
usually under tha dash or close to tha control box.. it should be in a small "mesh sack" of sorts at tha control box end of tha harness.. with oil injection module intact and wired tha way is supposed ta be you should get a short series of self check "beeps" when key is turned on?
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377168
08/08/17 01:17 PM
|
Joined: Nov 2006
Posts: 2,848
TLW
Extreme Angler
|
Extreme Angler
Joined: Nov 2006
Posts: 2,848 |
to check buzzer do this.. on tha starb side of motor at tha small term block where tha tan/blue wires are at you will see 1 goes to tha oilier module, one goes to that sensor on tha starb head and one goes into tha harness.. separate/disconnet tha one goin' to tha harness and "ground it" on tha block at tha screw holding tha plastic block to tha block.. this should set off tha buzzer.....
Last edited by TLW; 08/08/17 01:38 PM.
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377197
08/08/17 01:53 PM
|
Joined: Nov 2006
Posts: 2,848
TLW
Extreme Angler
|
Extreme Angler
Joined: Nov 2006
Posts: 2,848 |
same for you.. send me an email addy and send ya tha pdf oem manual....
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377225
08/08/17 02:11 PM
|
Joined: Jan 2005
Posts: 369
CWSANDERS
OP
Angler
|
OP
Angler
Joined: Jan 2005
Posts: 369 |
Cwsanders1013@yahoo.com
So if the oil injector runs out does it shut off injnition. I pulled some of the plugs last night too and they look new. No metal or anything
|
|
Re: 96 mercury 200 efi
[Re: CWSANDERS]
#12377270
08/08/17 02:44 PM
|
Joined: Nov 2006
Posts: 2,848
TLW
Extreme Angler
|
Extreme Angler
Joined: Nov 2006
Posts: 2,848 |
no.. nothing will shut it down on purpose except tha key and kill switch.. sent two.. let me know if ya get 'em
|
|
Moderated by banker-always fishing, chickenman, Derek 🐝, Duck_Hunter, Fish Killer, J-2, Jacob, Jons3825, JustWingem, Nocona Brian, Toon-Troller, Uncle Zeek, Weekender1
|