texasfishingforum.com logo
Main Menu
Advertisement
Affiliates
Advertisement
Newest Members
TraeMartin, Power-Pole CS, T-Rigger, JoeGoes, EcKo
119150 Registered Users
Top Posters(All Time)
hopalong 120,571
TexDawg 119,516
Bigbob_FTW 94,879
John175☮ 85,892
Pilothawk 83,260
Bob Davis 81,480
Mark Perry 72,282
Derek ðŸ 68,311
JDavis7873® 67,416
Forum Statistics
Forums59
Topics1,037,822
Posts13,935,129
Members144,150
Most Online39,925
Dec 30th, 2023
Print Thread
Page 1 of 2 1 2
Motorguide Xi5 Anchor Mode #12311134 06/26/17 02:37 AM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699


Hoping someone has had this issue and can be of some help. I have been able to take my boat out 3 times this year and each time I have problems with my Xi5. Last season it worked great and I never had any problems, but this year, I have had nothing but problems. The motor itself works great but when I attempt to put it into anchor mode the satellite light flashes for about 10-15 seconds and then stops, gives me the error tone, and goes back into manual mode. I have taken the motor to Boris Marine twice and they are apparently unable to repair the motor. The first time I took it, they said it was a bad GPS module, they replaced that and sent me on my way. I took it out, did the same thing that it had been doing. The second time, they replaced the entire board. I was finally able to take it out today and it was still doing the same thing. I have called Motorguide, they just tell me to take it to an ASC, but nothing is getting done about the problem. I have unplugged the unit starting with the negative wire multiple times, reset to factory calibration, setup the keel calibration, calibrated the GPS by traveling in a circle 2 times (I even get the confirmation beep), I replaced all 3 batteries to make sure that wasn't the problem, when on the charger I am getting 39V, so I know the voltage is there. I have synced and re-synced the remote a few times, even bought a foot pedal to see if the remote was the problem... nope. I am tired of having to take this TM 40 miles each way for an ASC to not be able to repair the issue. I was told by Boris Marine that they would not be replacing the motor even though it is under warranty and seemingly cannot be repaired. Im beyond frustrated with this unit and would love some advice or experiences to help me out. Thanks in advance!

[Linked Image]

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12311434 06/26/17 08:53 AM
Joined: Mar 2006
Posts: 1,020
J
javelin150 Offline
Extreme Angler
Offline
Extreme Angler
J
Joined: Mar 2006
Posts: 1,020
Have the tried the software update for the trolling motor? You can call Motorguide and they will send you dongle that plugs into your nmea system and it will do a software update that can help fix issue with the gps function of the trolling motor.

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12311450 06/26/17 10:40 AM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699
MG told me on the phone that my motor was manufactured after that update was already loaded on the motor. So it wouldn't work for me. However, Boris Marine states that they loaded the dongle update on the motor after the first time I took it up there. I had heard of this previously and thought it was the first thing to look into.

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12311455 06/26/17 11:09 AM
Joined: Mar 2006
Posts: 1,020
J
javelin150 Offline
Extreme Angler
Offline
Extreme Angler
J
Joined: Mar 2006
Posts: 1,020
Have you checked your nmea system? Is the nmea backbone getting power?

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12311514 06/26/17 12:38 PM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699
Yes, my NMEA is getting power, but I do not have this hooked up to my NMEA system right now.

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12312058 06/26/17 06:23 PM
Joined: Feb 2010
Posts: 12,096
shut-up-and-fish Online Content
TFF Guru
Online Content
TFF Guru
Joined: Feb 2010
Posts: 12,096

It does not matter if you have had the software update already. If you have lost satellite connection the software update "AGAIN" will resolve the matter most cases....


[Linked Image]
www.shut-up-and-fish.com
From *Sales, *Installation Services, and *On the shop floor Education & Instructional Tips
We have you covered here @ shut-up-and-fish for all of your Humminbird, Lowrance,
Garmin, Minn Kota & Motorguide needs plus much more - Call Now 972 822 9285
Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12315255 06/28/17 08:10 PM
Joined: Mar 2015
Posts: 117
V
voodew Offline
Outdoorsman
Offline
Outdoorsman
V
Joined: Mar 2015
Posts: 117
I had the same thing happen when I got mine well over 2 yrs agao --- they had to send me a flash drive to plug into the unit and reprogram it.
This used to happen if you deployed the trolling motor (or put power to it while the batteries were charging (to high of voltage)
Never had the issue again but I also never deploy the trolling motor when the batteries are charging

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12315846 06/29/17 01:32 AM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699
My first action was calling MG and asked them to send me the dongle. They refused and said that my unit was manufactured post update and it wouldn't help. I'm taking the TM to the shop again tomorrow.

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12316148 06/29/17 04:13 AM
Joined: Jul 2014
Posts: 4,340
B
Bobby Milam Offline
TFF Team Angler
Offline
TFF Team Angler
B
Joined: Jul 2014
Posts: 4,340
3rd time would be my last time. If it doesn't get fixed this time, I'd start moving my complaint up the chain of command and demanding it be replaced. Hopefully they'll figure it out this time but if not the squeaky wheel gets the grease.

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12317502 06/30/17 12:58 AM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699
Update was installed today and fixed the problem.

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12317584 06/30/17 01:45 AM
Joined: Jul 2014
Posts: 4,340
B
Bobby Milam Offline
TFF Team Angler
Offline
TFF Team Angler
B
Joined: Jul 2014
Posts: 4,340
Congrats and thanks for updating

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12317674 06/30/17 02:44 AM
Joined: Feb 2006
Posts: 3,738
B
bronco71 Online Content
TFF Team Angler
Online Content
TFF Team Angler
B
Joined: Feb 2006
Posts: 3,738
Thanks for letting us know the outcome, I have an Xi5 on the way!


1987 Nitro MX185/Mercury Black Max 150
1999 Triton TX21/225 Mercury Optimax
Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12318352 06/30/17 03:43 PM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699
When it's working, it's spot on!

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12318403 06/30/17 04:14 PM
Joined: Mar 2009
Posts: 2,516
L
lipjerk Offline
Extreme Angler
Offline
Extreme Angler
L
Joined: Mar 2009
Posts: 2,516
I had the same problem with mine when new, GPS module was replaced, and no problems since. I took mine to All Star Archery in Lewisville, they are an authorized MG repair facility, mine was repaired and back to me in a day.

All Star Archery & Marine
www.allstarmarine.com
201 S Mill St, Lewisville, TX 75057 · ~1.8 mi
(469) 549-1850
Open until 6 PM

Re: Motorguide Xi5 Anchor Mode [Re: Patrick M] #12457749 10/08/17 02:34 PM
Joined: Nov 2008
Posts: 699
Patrick M Offline OP
Pro Angler
OP Offline
Pro Angler
Joined: Nov 2008
Posts: 699
Well today the same issue resurfaced. Looks like I’ll have to get it reflagged again....

Page 1 of 2 1 2
Previous Thread
Index
Next Thread

© 1998-2022 OUTDOOR SITES NETWORK all rights reserved USA and Worldwide
Powered by UBB.threads™ PHP Forum Software 7.7.3